Finishing the Gulp DSII - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
This thread is privately moderated by Mark Canfield, who may elect to delete unwanted replies.
Jan 24, 2010, 02:13 PM
Registered User
Mark Canfield's Avatar
Build Log

Finishing the Gulp DSII

Went with uni on the elevons for some added stiffness. Also some uni at the trailing edge of the vertical stab (sharp as a knife). 2 layers of bi-directional tape on the wings, followed with Ultra coat for color. Finished wing with 2 layers of 10mil laminate, this thing won't bent, no way-no how
I've always had good luck with solar-tex on the fuse so after the bi-directional / goop series I covered with red solar-tex. A little to faded for my liking so 5 or 6 more coats of tinted red goop (Testers Red). Went with 4-40 rods and Sullivan linkage. The 5245's come with aluminum servo arms, and I used super tall Dubro T-style Large control horns. These seem almost comical at first glance but there is nothing stronger for this application and absolutely no slop at all Finished the elevon install with 3m 5200 silicon hinges, once again, nothing stronger IMHO. Maiden flight up at Weldon and she flew like a dream. Cruising in the 120's was effortless and no bad habits, I'm gonna like this.
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Advice needed please - gulp style fling wing stevext Flying Wings 1 Nov 16, 2009 09:27 PM
Discussion Building a Gulp SR LRFitch Slope 21 Nov 04, 2009 06:34 PM
Hacking extra channels in the GWS DSII? ndflicks Radios 0 Mar 20, 2005 07:58 PM
Gulp DSII video Mike_Y Slope 10 Jan 18, 2005 08:58 PM