CNC Foam Cutting problem with GMFC
I've been using GMFC 3.0.74 for several years now. Recently I downloaded the 30 days trial version of GMFC 3.0.86 and ran into the following problem:
The backlash comp. speed is not available as an input parameter anymore. In fact the compensation is VERY slow in the new version. Consequently, the cutting wire is virtualy standing and is burning away too much material at the highest and lowest point of the airfoil and every quadrant of a round spar.
My assuption is that it has something to do with the acceleration, since that is the major difference between the two versions.
Can anyone help me out on this one?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||4 axis wire foam cutting programs.||AirX||CAD/CAM||297||Mar 02, 2016 08:31 PM|
|Discussion||Cutting ½ to 1 inch foam with a razor knife||aerogel||Foamies (Scratchbuilt)||0||Nov 24, 2009 04:33 AM|
|Discussion||New to foam cutting ... not happy with my rig||richg99||The Builders Workshop||16||Aug 27, 2009 08:58 AM|
|FS: CNC Foam Cutting Information CD with bonus Multitester *EBAY*||Snef73||Aircraft - Electric - Airplanes (FS/W)||38||Feb 15, 2004 06:39 PM|