Shop our Airplanes Products Drone Products Sales
Thread Tools
Old Jan 02, 2010, 05:29 PM
bruff is offline
Find More Posts by bruff
EDF all the way!
bruff's Avatar
Discussion

Formost 150 & XPS Dynamax fan system


Flew the Formost 150 today with the XPS Dynamax fan system installed.
Looking at the pictures below you can see it is smaller than the Hoaye 5" fan. So basically it has no inlet on the fan. Fan sounds great. Flew it 3 times this morning. Here are the numbers from the Hacker/Spin 200 ESC. They were consistent between the flights. See here for the video.

Voltage 39.7
Amps 74.8
RPM 22,300
Timing 0
RTF weight 18 lbs
Exhaust dia. 4.25

Bob
Last edited by bruff; Jan 03, 2010 at 02:12 AM. Reason: correct voltage callout
Sign up now
to remove ads between posts
Old Jan 02, 2010, 07:35 PM
JimDrew is offline
Find More Posts by JimDrew
Xtreme Power Systems
Don't believe the SPIN 200 numbers. If you are flying with 10S then there is no way that you are seeing only 29.7 volts - that is only 2.97v per cell!

Also, since the fan housing is smaller (weird?), you should use an inlet ring if you can fit it... you will gain at least one more pound of static thrust.

Your exhaust cone is almost 1 full inch to large! You need shrink that to 3 3/8th (3.375"). Your top end speed is really suffering.

If you make these changes, you will find a totally new plane!
RCG Plus Member
Old Jan 02, 2010, 09:26 PM
corsair nut is offline
Find More Posts by corsair nut
fly like an EAGLE ;)
corsair nut's Avatar
i was going to say the same jim. i saw the id before i saw this post, and i said to myself...man, that tail pipe must be REALLY big! and it is! i agree bob, shrink that puppy down to atleast 3.5". and a simple foam lip for the upper portion of the fan wouldnt hurt either.
Old Jan 02, 2010, 09:39 PM
racer1 is offline
Find More Posts by racer1
5kW Club
racer1's Avatar
Bob may have the same problem I did when I first set up the Dyanmax on the Falcon. I only had a 6 inch thrust tube and when I had a 3.5 diamater it choke the thrust down and the plane did not perform.

Later testing I did using the T-jet was the tail cone needed to be at least 12 inches long before I could use the 3.5 exit.

Using a 6 inch exhaust I had to use about 3.75 for the exit.

Clay
Old Jan 02, 2010, 09:49 PM
corsair nut is offline
Find More Posts by corsair nut
fly like an EAGLE ;)
corsair nut's Avatar
that lip is probably really hurting it too.
Old Jan 02, 2010, 09:57 PM
racer1 is offline
Find More Posts by racer1
5kW Club
racer1's Avatar
At least I had an intake ring to help the Falcon work really well.

Clay
Old Jan 02, 2010, 10:43 PM
mpope1 is offline
Find More Posts by mpope1
Registered User
mpope1's Avatar
It seems to perform much better then the hoaye did!
Old Jan 03, 2010, 12:12 AM
FL62 is offline
Find More Posts by FL62
Average Joe 2 Semi-Pro n Back!
FL62's Avatar
I might have a special NACA 96005 inlet bowl around still that should fit the Dynamax fan - I just need to clean the cheerios out of it!
Old Jan 03, 2010, 12:15 AM
mpope1 is offline
Find More Posts by mpope1
Registered User
mpope1's Avatar
That is a very aerodynamic bowl, I think NASA uses them!
Old Jan 03, 2010, 01:46 AM
rvincent is offline
Find More Posts by rvincent
Renegade Fun Forever!!
rvincent's Avatar
I can hear the video but can't see it Sounds good though
Old Jan 03, 2010, 02:15 AM
bruff is offline
Find More Posts by bruff
EDF all the way!
bruff's Avatar
I'm, going to put the fan in the Venture (improved Formost 150) it has a full inlet ducting. I will reduce the exit diameter down also. You need a Divx codex for the video.
Bob
Old Jan 03, 2010, 12:36 PM
JimDrew is offline
Find More Posts by JimDrew
Xtreme Power Systems
Air Sally's ring is PERFECT for the Dynamax. Slips on and just works... and it looks good too!
RCG Plus Member


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion VERTIGO Formost 150 EDF conversion bruff Electric Ducted Fan Jet Talk 77 May 21, 2014 01:33 PM
Discussion XPS/LS Dynamax unit availability? Knife Liddle Xtreme Power Systems 55 Mar 21, 2012 02:27 PM
Sold Dynamax Ducted Fan km28104 Aircraft - Fuel - Jets (FS/W) 1 Dec 16, 2009 02:25 AM
Discussion NEW! VERTIGO Formost 150 V2.0 Fiberglass JET For EDF or Turbine Power! wingspan100 Electric Ducted Fan Jet Talk 12 Oct 15, 2009 12:36 AM
For Sale NIB Dynamax ducted fan propulsion system for OS .91 DF engine WARBIRDMAN Aircraft - Fuel - Airplanes (FS/W) 1 Jun 14, 2005 06:30 PM