Lumenier RB2205C-12 2400KV SKITZO Ceramic Bearing Motor
Thread Tools
Old May 10, 2003, 05:38 PM
t.nollett is offline
Find More Posts by t.nollett
Registered User

built my first li-poly packs, how do you test them?


just built my first e-tec 1200 li-poly packs, used rosin cored solder for the - terminals and solder.it aluminium paste for the + terminals.
i'm never to confident and like to tripple check what i do, so how do you check your packs befor shrink wraping them, i was thinking of a 5-6 amp load as they are 3s packs could i use a 12v light bulb say a 60w for a car. 60/12 = 5 amps is this correct, or would it be better to use my triton to discharge them at max amps
which is only 3 amps, not much of a test !!

t.n
Sign up now
to remove ads between posts
Old May 10, 2003, 07:58 PM
mikey702 is offline
Find More Posts by mikey702
Registered User
e-tec's are capable of around a 6C discharge rate so 1200s would give you 7.2 amps Max


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
How do you test a motor Steven9026 Parkflyers 25 Feb 06, 2003 03:44 PM
How do you test if pack is good ? quietfly Batteries and Chargers 5 Oct 28, 2002 01:57 PM
is my charge/discharge cycle killing packs - how do you look after yours ? Mark Sanders Batteries and Chargers 10 Oct 10, 2002 01:19 PM
How do YOU test/discharge your packs? hardlock Electric Plane Talk 2 May 28, 2001 11:02 AM
How do you test battery cell? stevesteve Beginner Training Area (Aircraft-Electric) 1 Apr 30, 2001 09:59 PM