Shop our Airplanes Products Drone Products Sales
Thread Tools
Old Dec 19, 2009, 06:56 AM
Bowerz is offline
Find More Posts by Bowerz
Once crash at a time
Bowerz's Avatar
Discussion

Swapping DX6i trainer switch, to non sprung switch?


Hi, ive been getting annoyed with having to hold the trainer switch when using the buddy box system. Can i swap it with a standard toggle switch (like the th. Hold/Mix one on the other side)? Will anything happen/will i loose any functions from doing this?

I understand they spring it so all you have to do is let go to regain control, but when flying a Co-ax heli with someone, i don't need the instant regain of control and i will keep my finger next to it ready to switch it back instantly.

Any thoughts?
Sign up now
to remove ads between posts
Old Dec 19, 2009, 08:37 AM
freechip is offline
Find More Posts by freechip
Surface, Air & Water Rc Toys..
freechip's Avatar
The other main issues with having the trainer switch spring loades is the its also use for BINDING.

If you forget to switch back or accidently turn it on while the radio is powered, the next time you will turn it ON it will go into bind mode and you will lose bnd with the RX.

But if its something you are will to live with, then by all means go ahead. I have replace the flap/gyro switch that was long and shape differently then the others so it would be the same as the others.

I prefer semitry, I think thats the word.
Old Dec 19, 2009, 10:00 AM
Bowerz is offline
Find More Posts by Bowerz
Once crash at a time
Bowerz's Avatar
I'm fine with the bind situation. I might replace the Th.hold/mix switch with a similar one to the other that i have. Then use the switch i took out to swap with the trainer as it would be good to have the extra length. The word you where looking for is symmetry.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion trainer switch/bind switch/brown out ryramZ Electric Warbirds 11 Dec 18, 2009 12:39 AM
Found WANTED: DX6i / DX7 - working or with broken program switch ok :WANTED kctrading Aircraft - General - Radio Equipment (FS/W) 5 Dec 02, 2009 10:44 AM
Question Switch harness for non BEC ESC using a CC BEC off the main TMO Power Systems 3 Nov 26, 2009 12:41 PM
Discussion DX 7 anyway to parallel Trainer Switch ? Has anyone done it? everydayflyer Radios 6 Oct 05, 2009 05:07 PM
Question Dx6i Trainer switch replacement=binding problems agraves73 Radios 0 Mar 05, 2009 03:18 PM