Nimbus 4-DM - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
This thread is privately moderated by veritus, who may elect to delete unwanted replies.
Dec 17, 2009, 12:13 AM

Nimbus 4-DM

Well I was able to sand the carbonfiber rod down to fit in the fuselage and inner panels. Inner panels have had gel-repair applied. although not as obvious to the human eye, stands out in photos. I have a feeling I will have to repaint these panels to match, we'll see; may have to repaint the whole sailplane but not till after test flight. Next is cutting down and fitting trailing edge positioning pins. Then making sure all wing servos and control surfaces are moving; I'm pretty sure they are. Then final balancing and total once over for overall integrity for flight.
Last edited by veritus; Dec 26, 2009 at 10:10 PM. Reason: Photos
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
electrified HKM 1/4 scale Nimbus 4 Thomas B Electric Sailplanes 19 Jun 05, 2004 05:36 PM