Shop our Airplanes Products Drone Products Sales
Thread Tools
Aug 26, 2010, 01:58 PM
five by five
sonicj's Avatar
My First (practical) Arduino Device
Sign up now
to remove ads between posts
Aug 27, 2010, 01:26 PM
Why is the Rum gone?
sim_io's Avatar
Quote:
Originally Posted by theothercliff
Transmitter battery voltage is a factor. You will get some added range if you get a 3 cell (11.1V-12.6V) Lipo for your transmitter. You can expect maybe 2 extra volts from a Lipo pack. Lipo packs speced out for RC transmitter use (shape, size, connector) are becoming common. Their power on time between charges is at least 4 times as long as a brand new nicad pack, although you ought to take the battery pack access cover off and charge it through the balance connector when you charge it once a month.

Cliff


Now if I get my Futaba 9c and replace its nicad pack with a lipo should the voltage increase do any damage to the radio?
Aug 27, 2010, 02:00 PM
Sam in Virginia
sverlander's Avatar
Quote:
Originally Posted by sim_io
Now if I get my Futaba 9c and replace its nicad pack with a lipo should the voltage increase do any damage to the radio?
I have been using a 3 cell lipo in my 9C for 3 years now with no problems. It's a Lightning Power 2650mah 3cell rated at 4C and with a full charge I can run the transmitter for 7 to 8 hours, I charge it when it gets down to 11 volts but I could run it lower. I'll never go back to ni-cads.
Aug 27, 2010, 07:22 PM
Videopilot
Derek_S's Avatar
Do you still charge it with the stock charger or a lipo charger? And where did you get it? My 9C nicad is getting iffy, low run times.
Aug 27, 2010, 07:37 PM
'FPV'er...not a "LOS'er
Vantasstic's Avatar
Quote:
Originally Posted by Derek_S
Do you still charge it with the stock charger or a lipo charger? And where did you get it? My 9C nicad is getting iffy, low run times.
Never charge a LiPo with anything but a LiPo charger. I've been running LiPo's in my Tx for years with no problems. I do not charge the LiPo through the Tx charge port. I always disconnect the LiPo from the Tx and charge directly from my LiPo charger. There may be no need to do it this way, but it just doesn't sit right with me to charge a LiPo though the radio's circuitry.
Aug 27, 2010, 08:22 PM
Sam in Virginia
sverlander's Avatar
Quote:
Originally Posted by Derek_S
Do you still charge it with the stock charger or a lipo charger? And where did you get it? My 9C nicad is getting iffy, low run times.
I got mine at Helihobby. They still have them on their site, PART#LP-B0106 $49.99 and are plug and play, They already have the correct connector for the radio.
http://helihobby.com/html/batteries.html
You can use any 3 cell lipo as long as it fits in the battery compartment and NEVER charge a lipo with anything but a lipo charger. I leave the lipo in the radio but take the back cover off and charge it with the balancing tap but I sometimes use my Thunder power 1010c charger so I replaced the Spektrum plug on the battery with a deans and charge though it and the charger monitors the cells though the balance plug.
Sep 02, 2010, 09:32 AM
When in doubt, throttle out...
badlands's Avatar
My 2nd V antenna, each one i make looks better than the last...

:-)
Last edited by badlands; Sep 04, 2010 at 07:02 PM.
Sep 02, 2010, 09:53 AM
Engineer for Christ
IBCrazy's Avatar
That's a good looking antenna. Very professional looking... better than mine
Sep 02, 2010, 10:08 AM
When in doubt, throttle out...
badlands's Avatar
Thx Alex, just having trouble finding a good location for it on my Stryker...


Martin
Sep 02, 2010, 06:47 PM
Why so serious?
2500GENE's Avatar
Quote:
Originally Posted by badlands
Thx Alex, just having trouble finding a good location for it on my Stryker...


Martin
I'd like to see some pics of your set up on the Stryker when you get it all sorted....if it's not too much trouble.
Sep 04, 2010, 12:57 AM
Rocket Programmer
jasmine2501's Avatar
I built this and stuck it in Depron to hold it... does it look ok?
Sep 04, 2010, 01:09 AM
Whats the wrst that can happn?
AdamChicago's Avatar
Newbie FPV base station question...how do I connect the power for everything?

The 2 receivers and diversity station each need power as well as the Fat Shark goggles...so that's 4 things requiring 12volt power. I have one 3s 2200 battery, so how do I make the connection between everything?? ...is it as simple as connecting all of the positives and then all of the negatives and then just plugging it into the battery? ...that would be way too simple, so do I need some kind of circuit board or voltage regulator...please help!!!

Thank youl
Sep 04, 2010, 03:43 AM
Registered User

Inverted Vee Tx with Moxon Rx


I have the HK 200mW 900MHz system and I built the antennas from IBCrazy's threads https://www.rcgroups.com/forums/show....php?t=1266148 and they have been working well. I haven't tested the full range yet but they definitely work better than the stock HK antennas (less interference and static).

I'm using a 7" cheapy LCD with a cardboard box over it, but it's still pretty hard to see.

I've posted some photo's of my setup for your amusement.
Sep 04, 2010, 11:39 AM
Rocket Programmer
jasmine2501's Avatar
Hey that looks nicer than what I'm doing with the goggles and all... I guess, if you make the antenna like mine up there, it's not "inverted" but just a V? What is the meaning of inverted, and does it matter?
Sep 04, 2010, 11:49 AM
five by five
sonicj's Avatar
Quote:
Originally Posted by jasmine2501
Hey that looks nicer than what I'm doing with the goggles and all... I guess, if you make the antenna like mine up there, it's not "inverted" but just a V? What is the meaning of inverted, and does it matter?
see here. it does make a difference which way the V faces.
-sj


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion trex 600e build your own fuse. catbalu Large Electric Helis 10 Oct 27, 2009 12:10 AM
Sold Build your own brushless motor sale pending Douglas Cheatwo Aircraft - Electric - Power Systems (FS/W) 1 Oct 07, 2009 11:26 AM
New Product Build your own two channel servo tester for less than $15! W9GFO Product Announcements 0 Sep 29, 2009 07:19 PM
Question Build Your Own Parkzone Mustang Question Blue Jacket Electric Warbirds 8 Sep 13, 2009 08:49 PM