Axe CP v3 RX Board / Belt Mod wiring HELP!
I am converting my Axe CP V3 to the Freestyle Belt mod, Witch requires you to install a motor ESC, and separate gyro.
On the CP V3 the 3 in 1 board usually handles supplying 1) power to the RX Board, 2) main motor speed and tail motor speed as well as gyro.
My problem is on the V3 RX Board there's 1 ~ 6 connections. 1,2 and 6 are for the 3 servo's that i know. But i am wondering where i should plug in the gyro, motor ESC and Supply power to the board.
I think board power is channel 3, Gyro is 4 and Motor ESC is 5. But i don't know for sure.
If someone who has done this mod and used stock RX TX PLEASE let me know how you wired it.
Thanks so much,
Last edited by Bladerrunner; Dec 19, 2009 at 08:06 PM.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|New Product||Helimax Axe CP Belt Mod||Rosella||Micro Helis||171||Feb 23, 2010 06:40 PM|
|For Sale||AXE CP V3 3 in 1, Tail Motor and Boom Assy||Bladerrunner||Aircraft - Electric - Helis (FS/W)||1||Dec 19, 2009 05:44 PM|
|For Sale||Axe CP V3 - 3 IN 1 and Tail motor||Bladerrunner||Aircraft - Electric - Helis (FS/W)||5||Dec 15, 2009 10:49 PM|
|For Sale||Axe CP V3 Like new !||plasticjoe||Aircraft - Electric - Helis (FS/W)||1||Dec 07, 2009 01:33 PM|