Fitting the Main Ldg Gear - RC Groups
Thread Tools
This thread is privately moderated by Float Flyer, who may elect to delete unwanted replies.
Nov 21, 2009, 02:41 AM
It actually Flies!
Float Flyer's Avatar

Fitting the Main Ldg Gear

I managed to fix the issue with the Ldg gear interference with the help of this great thread that is going on in the workshop.

I think I am getting to a lay out that I like. Though the Nacelles are still too large for scale, I think this is the best it is going to get. I might be able to choke the exhaust too much. I am really hoping to avoid filling two more engine holes with EDF's. I think the weight gain would be a bad trade off against slower landing speeds.

Next stop is the nose gear and working out a steerable, retractable mechanism.

Once I have the retract mechanism sorted for the nose gear, I can finally get to building frames, formers and ribs.
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Build Log F-18 Starmax 90mm Slats/Flaps/ldg gear/Scale mods fifisissi Foamy EDFs 1 Dec 19, 2009 05:32 PM
Discussion What Micro helis use Metal bevel gear on Main gear for tail shaft drive robinflyer Micro Helis 5 Oct 05, 2009 10:47 PM
Discussion Need bevel tail gear on main gear for micro heli like the Hornet robinflyer Micro Helis 1 Oct 04, 2009 02:26 PM
Discussion Some 4G3 tips: main gear, broken 2.9g tail motor shaft Beckler Micro Helis 3 Sep 03, 2009 10:54 PM
Help! Need a replacement ldg gear rene69 Flight Accessories 0 Dec 14, 2007 08:06 PM