Help me set up a FPV Plane
Hi Guys I am starting to build a purpose built FPV plane and I am interested in your component placement in the fuse outline attached.
I am on 2.4 DX7 AR7000 with a 900mhz downlink.
I am thinking of running a 3 db antenna on the vid tx.
I also was thinking about running the remote rx all the way to the tail but there will be 2 carbon fiber push rods nearby. Will this cause issues?
Let me know how you would lay out your components for the least interference.
you should be good..
The Carbon in a fully inclosed fuselage act as shielding and has been known to block out some singles. But Carbon fiber is not likely to distort and absorb the single as metals some times do. Some times called sapping. If your Receiver, is under the carbon fiber your good.
Ps I got some more foam to day and going start laying out my AP Super S
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||help i need to set up my brushless suhkoi by parkzone||piperj3cubman||Micro Ready-to-Fly||2||Dec 19, 2009 11:42 AM|
|Discussion||Inexpensive wireless CCTV set-up for FPV, or...?||latinlax01||Hot Online Deals||7||Nov 01, 2009 09:28 PM|
|Discussion||LIGHTING UP your FPV plane||jetstreaming||FPV Aircraft||13||Sep 28, 2009 10:10 PM|
|Question||Best FPV set up?||flyboy321||FPV Talk||27||Sep 06, 2009 09:14 AM|
|Help!||Help with my first FPV set-up||Greeney||FPV Talk||3||Feb 26, 2009 11:13 PM|