[Question] : Foam cutting correct sequence
Hi all !
I have a question for the Foam-builders-Pro :
When someone want to build an airplane with a hot-wire foam cutter, what's the correct sequence of the cuts, if he want to cut the formers and the wing attach ?
For example, i followed the buildlog of Sparky's B25, and he has cutted the wing attach after the fuse was completed.
I know this was almost "easy" to do because the bottom side of the fuse is flat, but how to do the same thing if i want to build an airplane with a round bottom ? How i can put it flat on the table, to draw and cut the wing attach ?
Sorry for my english, i hope you've understand my question...
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Foam Cutting Question||mt_100||Foamies (Kits)||2||Sep 28, 2003 06:50 PM|
|foam cutting noob question||johnny_carlos||Foamies (Kits)||3||Jan 22, 2003 11:46 PM|
|Question about foam cutting...||NetForce2K||Foamies (Kits)||1||Jun 20, 2002 04:33 PM|
|Another foam cutting question....filament...||JayParke||Foamies (Kits)||3||May 26, 2002 06:47 PM|
|Foam cutting - electronics question AC to DC||ChrisD||Power Systems||5||May 02, 2001 06:11 AM|