Need RS380PH number for MotoCalc & Thrust computation
Could someone send me or tell me were to get the MotoCalc numbers for a RS380PH?
Need Constant, Current, Resistance and Weight.
MotoCalc has RS380SH but it bears little resemblance to my actual numbers (A,V,W,RPM).
How do you compute thrust from pitch & rpm?
I am running salvaged SoarStar gear (RS380PH, 1,85:1GB, 8x4 on 8x600AE) on a scrap built that is close enought to done to let me get a good guess at AUW. Trying out battery/prop combos to see what appears to work best.
During static tests I got
At 30 Seconds:
9.9A, 8.0V, 80W, 7950RPM - computed static speed = 30mph
At 2 minutes (350maH used)
9.0A, 7.3V, 67W, 7350RPM - computed static speed 27.8mph
Unfortunately the designation RS380PH only tells part of the story. A complete designation would be something like RS-380PH-4075. The last four digits indicate the size of the wire and the number of turns; ie, 75 turns of .40mm wire (I have no idea if that's an actual 380 wind). The only difference between a 4.8V Speed 400, 6.0V and a 7.2V is the winding, in other words all three motors are RS-380PH's but the last four digits would be different for each motor.
The E-Zone FAQ describes how to measure all three motor constants, here: http://www.ezonemag.com/pages/efaq.htm#motor16
I believe the SoarStar motor is the same as a 6V Speed 400, with a flux ring. The flux ring will slightly reduce the Kv and Io but would have no effect on Rm.
Hope this is of some help.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||need a peak charger for low amp batteries||Cliff Smith||Batteries and Chargers||3||Sep 21, 2005 03:57 PM|
|Need motor info for motocalc||MUDBOGGER2||Power Systems||0||Jan 13, 2005 03:03 PM|
|need part number for hornet II autorotation kit not sure if im right||falcon41176||Micro Helis||3||Dec 21, 2004 12:18 AM|
|Actro 32 series - need motor constants for motocalc.||rcjetpilot||Power Systems||2||Nov 20, 2004 11:42 AM|
|Motocalc & Thrust||jbird||Power Systems||9||Nov 05, 2003 09:41 AM|