Thread Tools
Old Aug 25, 2009, 08:08 PM
time $pent is offline
Find More Posts by time $pent
Registered User
Help!

newbe needs help


does anyone know what size lipo to use in my 32" mono w/ a 9 turn 540 xl feigao and a 180 a seaking speed control?
Sign up now
to remove ads between posts
Old Aug 25, 2009, 09:14 PM
Rex R is offline
Find More Posts by Rex R
Registered User
assuming that you would like a bit more than a 1minute run...I'd use a 4s2p (a pair of 4s 4500mah or higher 25c packs).
rex
Old Aug 25, 2009, 09:24 PM
time $pent is offline
Find More Posts by time $pent
Registered User
thanks, ive been winging it so everything helps...
Old Aug 26, 2009, 04:32 PM
time $pent is offline
Find More Posts by time $pent
Registered User
can i run 2 batteries at half of the mah to equal one larger battery due to battery location?
Old Aug 27, 2009, 10:12 AM
ED66677 is offline
Find More Posts by ED66677
Registered User
yes, connect them in parallel
Old Aug 29, 2009, 01:00 PM
time $pent is offline
Find More Posts by time $pent
Registered User
so i'm wondering, does my c rating go up if i wire two batteries in series or parallel?
Old Aug 29, 2009, 01:10 PM
ED66677 is offline
Find More Posts by ED66677
Registered User
it goes up when in parallel
to simplify, parrallel increase Amp (C rating and capacity) serie increase Volt
Old Aug 29, 2009, 01:49 PM
time $pent is offline
Find More Posts by time $pent
Registered User
thanks ED. one of the last things that i need to do is build my battery trays on the sides of my mono, are their any links for this task? getting close to sink or swim time...lol
Old Aug 29, 2009, 02:35 PM
ED66677 is offline
Find More Posts by ED66677
Registered User
in my 29" DF copy I have just a stripe of 3M hook and loop (Velcro) in the hull and same on each batt (2x2S in serie), each stripe is as long as the batt, can't move!
Old Aug 29, 2009, 03:31 PM
time $pent is offline
Find More Posts by time $pent
Registered User
i call mine a 33" delta farce i sure hope it floats when i get done. all i need is a radio and receiver and lipos and it should be ready to explode or run...
Old Aug 29, 2009, 04:50 PM
ED66677 is offline
Find More Posts by ED66677
Registered User
lol
Old Sep 05, 2009, 03:32 PM
time $pent is offline
Find More Posts by time $pent
Registered User
now i'm wondering if my motor mounts are going to hold with 15 minute epoxy, or should i go over them with fiberglass?
Old Sep 07, 2009, 02:48 AM
ED66677 is offline
Find More Posts by ED66677
Registered User
yep add some fiberglass to the 15min epoxy
Old Sep 27, 2009, 11:58 PM
time $pent is offline
Find More Posts by time $pent
Registered User
does anyone know what a good balance point would be for this 32" mono?
Old Sep 28, 2009, 01:36 AM
ED66677 is offline
Find More Posts by ED66677
Registered User
8.2" from transom, that's 25% of the hull lengh


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Help! newbe needs help!!! time $pent Racing Boats - Electric 4 Aug 09, 2009 04:30 PM
Discussion newbe needs help with lipos PETEREL Batteries and Chargers 5 Jan 08, 2007 04:34 PM
Newbe needs help retouching pic's Ron Merigold Aerial Photography 10 Mar 14, 2005 03:02 AM
Newbe needs help in WV jkolp Fuel Plane Talk 2 Feb 05, 2005 09:14 AM
Newbe needs help in West Virginia jkolp Electric Plane Talk 2 Feb 04, 2005 10:29 AM