MOunting EDF units that lack the mounting lugs - RC Groups
Thread Tools
Aug 25, 2009, 04:52 PM
Registered User
byrocat's Avatar

MOunting EDF units that lack the mounting lugs

I just acquired a pair of 55mm fan units from eBay and am looking at mounint at least one of them in a model. Or at least a test rig.

What's the best method of mounting it? I'm assuming that you should have two bulkheads to give good support and glue surface.

Also, the unit has an integral bell mouth. Is it worthwhile grinding it off or just run the ducting down into the bell to minimize flow losses?
Sign up now
to remove ads between posts
Aug 25, 2009, 05:54 PM
Big gov never Works
St. Martin's Avatar
Curiously, I have a similar situation in my WBK A4 Skyhawk proto. I used the Wattage shroud. On one shroud I cut the "bell" off and the shroud went out of round and was very weak. So, I used it stock. And ran the intakes right up to it. It does not lack in performance. It originally used a cut down KY rotor to good performance on a Mega /3 and 4s. It's even faster on an old cut minifan rotor.

The fuselage seperates at the fan's bell mouth. The fan siliconed to the rear fuse bulkhead. The secound proto uses the WeMo 505 and K&A glass shroud. I added a muli layer 1/64 ply ring around the shroud. It is mounted to the forward fuse, tacked in place and the rear fuse bulkhead has tabs the push it against the forward fuselage.

You could add mounting tabs. To do this use 3/32- 1/8" ply and mount with rubberized CA from Bob Smith. NO KICKER. It makes the CA brittle. Rough up the shroud where attaching.

Hope I helped


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Mounting EDF Units tiggs Electric Ducted Fan Jet Talk 13 Jun 23, 2002 12:18 PM
Wattage Lightning and Litestik w/2 GWS EDF units.--SOLD bruff Aircraft - Electric - Airplanes (FS/W) 5 Apr 27, 2002 01:17 PM
What EDF is that? Ado Electric Ducted Fan Jet Talk 3 Oct 22, 2001 04:55 AM
Vasa Edf Units In My Suitcase EAMRC Electric Ducted Fan Jet Talk 4 Sep 30, 2001 09:36 AM
EDF kit that has... Yoyodyne Electric Ducted Fan Jet Talk 3 Jun 27, 2001 05:30 PM