|
|
Thread OP
|
Discussion
Top Gun Park Flite Super Cub PA18 - Propeller Setup
Hi all
Should be an easy question for you. Excuse my ignorance but I'm kinda new to all of this. What is the correct setup for fitting the propeller onto the shaft. I currently have it as follows: Moving from motor to end of shaft M3 Nut - Washer - M3 Nut - Propeller (nut goes into the propeller) text on propeller faces forwards - washer - tightening nut (shiny metal thing I think its called Prop adabter nut) - Spinner. How far should the spinner be to the prop? I can't push the spinner into the "Prop adabter nut" all the way just half way as the "Prop adabter nut" has a groove half way and its difficult to push it any further. Should the Prop adabter nut fit flush inside the spinner? Thx |
|
|
|
|
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Discussion | Top Gun Park Flite Cessna EP - Wing Servo Hinge | G4ORCE | Foamies (Kits) | 0 | Aug 19, 2009 07:00 AM |
Discussion | Top gun park flite super cub | craigtgpf | Electric Plane Talk | 6 | Aug 14, 2009 02:50 PM |
Question | HZ super cub vs. top gun park flite super cub | archeryman93 | Beginner Training Area (Aircraft-Electric) | 13 | Feb 04, 2009 10:49 AM |
New Product | Top Gun Park Flite TB-20 any opinions? | MustangP51 | Parkflyers | 4 | Jan 07, 2009 01:24 PM |
Discussion | Top Gun Park Flite Extra 330 ? | Pimpy S | Foamies (Kits) | 3 | Sep 27, 2008 04:25 PM |