ParkZone Super Decathlon brushless - control surface throws - need some setup help
I have a ParkZone Super Decathlon brushless and am trying to setup the throws \ deflection for the rudder and elevator.
I know enough to know that more is not always better on the hi rates but thats about where my knowledge stops.
I looked in the manual and searched without results.
Was looking to see if anyone had good recommended deflection measurememts in mm for low and hi rates similar to the information here on page 33-34
for the E-flite Apprentice
thanks - great review
What I was trying to figure out is if there was a point of diminishing return when getting a lot of throw on the control surfaces
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Article||ParkZone Super Decathlon Brushless RTF Review||ghee-grose||Parkflyers||253||Jan 02, 2017 09:57 AM|
|New Product||Parkzone Super Decathlon Brushless||Bajora||Parkflyers||77||May 14, 2010 07:21 PM|
|Sold||ParkZone Super Decathlon Brushless RTF, Tailwheel, Trainer, Like New, $120.00 Shipped||KingJoe||Aircraft - Electric - Airplanes (FS/W)||1||May 11, 2009 08:26 PM|
|Logo10 kit arrived, need some setup help.||PierreVC||Electric Heli Talk||14||Jul 17, 2002 03:42 AM|
|Control Surface Throws for TM??||AndrewsJr||Parkflyers||4||Mar 24, 2002 12:00 PM|