Thread Tools
Jun 19, 2009, 05:15 PM
Registered User
bsfixit's Avatar

exceed 2.4 ghz RX and TX for heli and planes

I got the RX TX combo in pretty quick order of time. I read the entire book
and installed the drivers on my Vista PC. looked at the programmable settings and then tried to "bind" the RX to the TX. the RX nor the booklet has the polarity for the battery to connect to the RX. so I cannot get the TX to control anything with the RX.. no lights on the RX .. nothing works..
Doesn't most receivers show the right direction to connect servos and battery connectors. I did a search in this forum and sent an email to support.
So .. is this Rx toast? the TX works fine on the PC and config program..
Anyway .. could use some help
Sign up now
to remove ads between posts
Jun 20, 2009, 09:31 AM
Registered User
bsfixit's Avatar
Anyone? looking at older radios I have . the Battery connection can only go in one way, like a keyway. this RX has nothing like that .. you cant plug in servos and batteries or ESC in only one direction. I think a simple wiring diagram would be needed for this RX and which servo or plug types is right for this RX. This is frustrating.. I wanted to mod my plane from 2 channel to 3 this weekend .. I am going to try support phone number but I doubt they are open on saturday..
Last edited by bsfixit; Jun 20, 2009 at 05:16 PM.
Jun 23, 2009, 03:51 AM
Registered User
hobbypartz's Avatar
To bind:
You must connect the bind jumper to the battery port on the RX. Then connect the a RX battery to the chan 3 or ESC. Yes there is a polarity to the RX and center wire is positive, right of it is negative, and left of center is signal. Once you plug it in the RX will be flashing red light. That means it's ready to accept the binding code. Go to the TX and press and hold the bind button, then turn on the TX. Once the code has been sent to the RX the light will stay solid. That means you have just successfully binded the TX and RX.

There is no wiring diagram but this RX follows the same exactly wiring diagram like any other RX on the market. Keep this in mind: center wire is positive, right of it is negative, and left of center is signal. This is true if you held the RX in your hand and the short antenna is on the left. If you held the RX in your hand and the short antenna is on the right then think the opposite. Let me know if you need more help.

Aug 01, 2009, 12:46 AM
Registered User
will you be getting more of these 6ch tx/rx combos? can you pm me the response. thanks

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold Futaba 10c 2.4 Ghz Rx and Tx New $460 cbcalhoun Aircraft - General - Radio Equipment (FS/W) 7 Apr 01, 2009 11:48 AM
Sold Futaba 6EX 2.4 GHz Tx and R606FS 2.4 GHz Rx davidsons Aircraft - General - Radio Equipment (FS/W) 3 Mar 10, 2009 11:42 AM
Discussion 2.4 Ghz Rx for under $30 LAN Radios 12 Nov 30, 2007 03:04 PM
New Product New 2.4 Ghz Rx and Tx module for existing Transmitters! ex-racr Radios 1 Sep 07, 2006 11:29 AM