Thread Tools
Old Jun 15, 2009, 07:30 AM
stemasoft is offline
Find More Posts by stemasoft
Registered User

Readout RPM and Temperature out of Lambert Kolibri Turbine

Another customer want's to know if it's possible to read out the RPM's (about 250'000/min) and as well the temperature via the ECU-FADEC (JetECU Interface Cable) out of his Lambert Kolibri Turbine ( here's the link to )

Could anyone help? That's the only question that's left!

Sign up now
to remove ads between posts
Old Jun 16, 2009, 02:04 PM
billpa is offline
Find More Posts by billpa
billpa's Avatar
Hi Stemasoft,

Yes, that should work fine, as long as the ECU used with the Kolibri is the FADEC. I looked at the photo on the website, and it sort of looks like the FADEC, but I did not see it explicitly mentioned on the website.


Bill, for Eagle Tree
Site Sponsor

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold Eagle Tree V3 150A with RPM and temperature sensor! sircrashesallot Aircraft - General - Miscellaneous (FS/W) 2 May 15, 2008 08:59 PM
Discussion RPM and Temperature Sensor wadiprawita UAV - Unmanned Aerial Vehicles 7 Aug 02, 2007 08:35 PM
Discussion Lambert Kolibri nickhawk Fuel Jet Talk 3 Dec 19, 2006 12:37 PM
Discussion Lambert Kolibri nickhawk Fuel Jet Talk 0 Nov 05, 2006 11:23 AM
Discussion RPM, Throttle, Temperature, Voltage Data From ESC-View MDrive Power Systems 0 May 26, 2006 10:16 PM