Yaw does not work - RC Groups
Thread Tools
Jun 02, 2009, 12:34 PM
Registered User

Yaw does not work


I am trying with UAVP 3.15 (original), but yaw command does not work.
(turned off all PID parameters, to see manual commands)

My TX/RX is JR 388S with mode 1, and uses a composite signal.

The symptom is "Receiver" screen shows all commands work fine
(gas, roll, nick, yaw and ch5), and actually roll, nick and gas are working,
except yaw.

Another words, If I move the right stick to right, UAVP moves right, and
if I push the left stck, UAVP moves forward. (mine is mode 1)

However, If I move the left stick to left, nothing happens.

The thing I don't understand is, why "Receive" screen shows OK, while
actual yaw command does not work...

I tried with non-composite signal also, but the result was same
(connected individual ch1, ch3, ch5 and ch7)

Could someone please help me?

Last edited by eaton; Jun 02, 2009 at 02:08 PM.
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Say you bought something from a E-zoner and it does not work? LJH Vendor Talk 21 Sep 23, 2003 04:07 PM
FMS (the tx does not work) thor4944 Electric Plane Talk 10 Jun 11, 2003 07:41 AM
Cockpitmaster does not work on new computer? thor4944 Beginner Training Area (Aircraft-Electric) 2 Jun 10, 2003 08:02 PM
New Ezone layout does NOT work for me BEC Site Chat 7 May 23, 2002 01:14 PM