Thread Tools
Old May 29, 2009, 12:48 PM
mmormota is online now
Find More Posts by mmormota
Registered User
mmormota's Avatar

Fasst dropout test with Remzibi OSD

I modified a remzibi osd and a Futaba Fasst receiver to display information on the dropout rate of the receiver. This mod makes the fpv flight more reliable, gives an early warning before loss of control.
This video is the first indoor test of the mod.

The Tx was in range test mode and in critical distance. I lowered the signal by shielding the Rx aerials by hand. The displayed value (the % on the bottom) is proportional to the error rate.
Check the blinking of the green led (good signal) and red led (dropout), the movement of the servo and the corresponding dropout % displayed.
Last edited by mmormota; May 29, 2009 at 08:37 PM.
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Blitz 400 Flight Test with Wattage Cobalt... Captain Carlton Foamies (Kits) 38 Apr 02, 2009 11:27 PM
Flight Test with Datalogger peterangus Modeling Science 1 Apr 10, 2005 05:54 AM
Fighterbird test with the Aerobird X-pack tail Ed F Parkflyers 6 Jun 13, 2003 08:25 PM
Fighterbird test with the Aerobird X-pack tail Ed F Parkflyers 1 Jan 21, 2003 02:41 PM
Mugi flight test with bungee! Vinnya42 Foamies (Kits) 2 Dec 18, 2001 01:29 PM