Thread Tools
Sep 25, 2012, 05:16 PM
Never enough time to fly!
ecase's Avatar
Quote:
Originally Posted by jetpackninja View Post
Blu-
Pretend you are driving a Nascar oval up in the air.
Fly mostly at half throttle.
Attempt to fly formation in a tight pack going around the oval.
When you find yourself behind your friends plane goose the throttle to overtake him.
If you pass him, no big, slow down and let him attempt to pass you in the same way.
This is how we maximize hits, I witnessed a couple of good freinds hit each other three times within a few seconds using this method just this weekend
Don't believe anything a Ninja tells you! They are very deceptive!
Sign up now
to remove ads between posts
Sep 25, 2012, 05:35 PM
Planes in flames,,,
jetpackninja's Avatar
Quote:
Originally Posted by ecase View Post
Don't believe anything a Ninja tells you! They are very deceptive!
That's the truth. Or is it...
Sep 25, 2012, 06:38 PM
Where did that tree come from
kid at 55's Avatar
I ran across this video. It's look like an indoor Swarm event.
RC Plane Battle-More Than 50 Plane Dogfight At Once-EFest 2012 (9 min 18 sec)
Sep 26, 2012, 11:16 AM
Converting O2 to CO2
Left Coast DJ's Avatar
Can the Assassin rock 'n roll on a HobbyKing D2826-6 2200kv Outrunner Motor?
Sep 26, 2012, 12:08 PM
Registered User

Rock and Roll


Quote:
Originally Posted by Left Coast DJ View Post
Can the Assassin rock 'n roll on a HobbyKing D2826-6 2200kv Outrunner Motor?
Its been done a few times I would think, just add enough weight to the nose or move the battery forward to compensate for the difference in weight of the two motors. That's why the little red motor is used, it's powerful, light and reliable, oh and it screams when it gets 24g wire wound 9 turns, it adds a considerable amount of power without adding that dreaded nose weight.
Good luck and have fun expermenting and learning.
Sep 26, 2012, 12:23 PM
Registered User
hobie14's Avatar
Quote:
Originally Posted by Left Coast DJ View Post
Can the Assassin rock 'n roll on a HobbyKing D2826-6 2200kv Outrunner Motor?
I've measured the above motor versus the famous Assassin red motor and TGY motor comes in at 10g more than the red motor ..... not a big difference and easy to balance for ......

I've done the same conversion on a Depron Delta KFm4 wing and the results are outstanding ........
I have a second Assassin which I will almost certainly convert in the near future but in the mean time go ahead and let us all know the results you get ...... I'm sure you wont be dissapointed ......

One thing ...... use as high a C rated battery as you can, particularily if your using the 1350 size ....... the TGy motor could well pull 35 (ish) amps so allow for this in your choice of ESC .....
Sep 26, 2012, 01:00 PM
Registered User
Quote:
Originally Posted by Bluhammer View Post
The amazing thing is how hard it is to make contact. We have flown about 6 flights against each other in the last few weeks, and maybe just barely touched twice.
Blu
I am no where near an expert at combat, but here's my take on it.
I think what most people miss is that combat is largely a cooperative sport, not competitive. If everybody is up there flying full speed with PopWing and Assassin-sized planes and trying to be evasive, it is very difficult to hit another plane. It's mostly just frustrating and tedious. If you really love midairs, the best way I've found is to fly a predictable path (the dreaded racetrack). Planes are most vulnerable at the turns at the ends of the path. If you don't fly a set path, then it helps if the pilots announce what they are going to do. I know that doesn't sound like a competitive game, but my friend and I, both rank amateurs, generally get one good mid-air for every hour of trying and that's what we fly for. The holy grail, the head-on midair, takes a lot of planning, a lot of cooperation, and a lot of luck. We only have one so far.
Sep 26, 2012, 04:52 PM
Luis Claudio - Rio - Brazil
Luis_Claudio's Avatar
I lost it I arrived sunday morning and my assassin was not there anymore

But life goes on! Here we go! My brand new Assassin is just waiting for one servo to the maiden!

I have a Spektrum DX6I and I lost connection two times. Even with a full range receiver and new battery and eletronics. As I bought a new radio for me, a Hitec Aurora 9, I am just waiting for the receivers arrives to say good bye forever to the DX6I

Quote:
Originally Posted by hobie14 View Post


I think we are all quietly waiting for news from Luis Claudio - Rio - Brazil re his Assassin that is stuck up a very high tree .....
Sep 26, 2012, 08:53 PM
Registered User
I have this motor and it screams with a 6x4 prop and or 6x3. Not enough power and a lot of noise o 5x5. Next I will try a 6x5 prop.
Sep 27, 2012, 12:35 PM
Registered User

Sorry for the loss Luis


Quote:
Originally Posted by Luis_Claudio View Post
I lost it I arrived sunday morning and my assassin was not there anymore

But life goes on! Here we go! My brand new Assassin is just waiting for one servo to the maiden!

I have a Spektrum DX6I and I lost connection two times. Even with a full range receiver and new battery and eletronics. As I bought a new radio for me, a Hitec Aurora 9, I am just waiting for the receivers arrives to say good bye forever to the DX6I
I'm going to put my e-mail address on my Assassin having almost lost it in the weeds.
Good looking replacement, good luck with it.
Sep 27, 2012, 01:17 PM
Registered User
hobie14's Avatar
Quote:
Originally Posted by cmaynex View Post
I have this motor and it screams with a 6x4 prop and or 6x3. Not enough power and a lot of noise o 5x5. Next I will try a 6x5 prop.
I run mine on 7 x 4 .......
Sep 27, 2012, 01:20 PM
Registered User
hobie14's Avatar
Quote:
Originally Posted by Luis_Claudio View Post
I lost it I arrived sunday morning and my assassin was not there anymore

But life goes on! Here we go! My brand new Assassin is just waiting for one servo to the maiden!

I have a Spektrum DX6I and I lost connection two times. Even with a full range receiver and new battery and eletronics. As I bought a new radio for me, a Hitec Aurora 9, I am just waiting for the receivers arrives to say good bye forever to the DX6I
Sorry to hear that news LC ...... time to move on with a new Assassin and Tx .....
Sep 27, 2012, 04:41 PM
Registered User
I just finished my Widowmaker and Scythe the other day and finally got the chance to fly them today. They glide so very nice. This is my third Widowmaker and I've gotten much better at putting them together.
Sep 27, 2012, 08:40 PM
Luis Claudio - Rio - Brazil
Luis_Claudio's Avatar
I had to do that before, too late! Now Ill put my phone and email in the others

Thank you so much Chico!

Quote:
Originally Posted by Chico John View Post
I'm going to put my e-mail address on my Assassin having almost lost it in the weeds.
Good looking replacement, good luck with it.
Sep 27, 2012, 08:41 PM
Luis Claudio - Rio - Brazil
Luis_Claudio's Avatar
I cant wait to maiden my new Assassin with my NEW Hitec Aurora 9

Quote:
Originally Posted by hobie14 View Post
Sorry to hear that news LC ...... time to move on with a new Assassin and Tx .....


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Qjet Flamingo & Butterfly: A plane no one has!! romans1015 Parkflyers 3 Sep 04, 2016 05:47 PM
WALLY WING...no fins...flies great!!! gpw Foamies (Kits) 32 Aug 31, 2016 08:21 AM
Qjet Flamingo & Butterfly: A plane no one has!! romans1015 Parkflyers 6 Jan 29, 2004 04:05 PM
Noob concept plane Mikey C. Foamies (Kits) 5 Nov 11, 2003 01:05 PM
It's a boat...It's a plane...no! It's flightship! MrBungle Electric Plane Talk 24 Jun 26, 2001 01:55 AM