Spektrum AR6200 Bind Problems
I am still getting used the Spektrum module in my Optic 6 and spektrum receivers. I encountered some isses binding my AR6200 and thought I would share the lessons learned.
I had just installed a new module in my Optic and proceeded to bind to the AR6200. I followed the standard procedures but the receiver would not bind. When the transmitter was turned on the receiver lights would turn off, the remote receiver light would go solid and then both receivers would start blinking again.
Thinking it may be a problem with the receiver I tried an AR6250 and it bound just fine.
So then I tried a new AR6200 and it would not bind. Eventually I got both receivers to bind.
1. Keep the Tx a couple feet away from the Rx when binding.
2. Make sure both the main and remote receiver antennas are perpendicular to the Tx and not pointing directly at it.
3. Use a good battery I usually bench test with a used 9v battery. The 9 volt I was using to bind must have been too low and when the receiver tried to bind it was pulling too much voltage out of the battery causing the process to start over.
Point 2 should not make any difference unless you are too close in the first place. Then antenna orientation could matter, but only because the signal is too strong.
Point 3 is not correct. The voltage, as long as it's within the operating range (3.5-9) should not make a difference to binding. Use a 4.8 or 6 volt battery or the regular ESC or BEC. In particular, don't use a higher voltage with the servos plugged in as many types can be damaged.
The most common reasons for problems in binding are:
Transmitter too close.
Failing to press and hold the bind button before turning on the transmitter.
Failing to wait long enough with the button still pushed for binding to take place (allow at least 30 seconds -- though usually it's much quicker than that).
Mistakes in plugging things in (e.g., reversed plugs)
Defective bind plugs.
Forgetting to remove the bind plug after binding.
Accidentally pressing the bind button on the transmitter.
Funny you would mention defective bind plugs as the one I was using was suspect so I got another one.
In regards to the battery, I connect the 9v to the BEC. Once disconnected the 9v and used a transmitter pack the receiver would bind. It wouldn't bind with the 9v probably because it was almost discharged. The same thing would happen with a 4.8v receiver pack if it was discharged.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||spektrum ar6200 problems||ian.c||United Kingdom||1||Apr 23, 2009 02:44 PM|
|Help!||spektrum ar6200 problems||ian.c||Large Electric Helis||3||Apr 17, 2009 05:11 PM|
|Discussion||Spektrum AR6200 refuses to bind||dontbother||Radios||3||Feb 07, 2009 10:17 AM|
|Discussion||Spektrum AR6200 & 900mhz 500mw VTX Success or Problems?||EyeFlyPlanes||FPV Talk||53||Jan 10, 2009 11:12 AM|
|Help!||Spektrum Module Bind problems||helitaiwan963||Electric Heli Talk||18||Apr 18, 2008 06:37 PM|