Thread Tools
Old May 10, 2009, 11:10 PM
robh is offline
Find More Posts by robh
Good, fast or cheap, pick two
robh's Avatar
Discussion

Help setting up v-tail function with Eclipse 7 - no ailerons


Hi,

I'm trying to figure out the best way to setup a v-tail on an electric sailplane with no ailerons. I want the motor on a switch, and to be able to use the right stick for controlling pitch and yaw attitude.

Any ideas are greatly appreciated!

Rob
Sign up now
to remove ads between posts
Old May 14, 2009, 11:29 AM
TOhm is offline
Find More Posts by TOhm
Hitec / Multiplex USA
You can set the Eclipse to glider mode/2-wing. Then go into the edit menus and select vtail. This will give you vtail on 2 and 4. Then go into A-R mix and enable it. This will mix the aileron to the rudder. No everything is on the right stick and the throttle is on a switch.

Tony Ohm
Hitec/Multiplex USA
Old May 14, 2009, 09:24 PM
robh is offline
Find More Posts by robh
Good, fast or cheap, pick two
robh's Avatar
Quote:
Originally Posted by TOhm
You can set the Eclipse to glider mode/2-wing. Then go into the edit menus and select vtail. This will give you vtail on 2 and 4. Then go into A-R mix and enable it. This will mix the aileron to the rudder. No everything is on the right stick and the throttle is on a switch.

Tony Ohm
Hitec/Multiplex USA
Thanks very much for the info Tony. Also, if I have two spoiler servos, would they then go into channels 1 and 5, then set them up using Crow? I'll give it a try, and see if that works.

Rob
Old May 15, 2009, 11:51 PM
robh is offline
Find More Posts by robh
Good, fast or cheap, pick two
robh's Avatar
Tony...?

If I have two spoiler servos, would I wire them together and use a single connector on the receiver, or could I keep them separate and use which receiver plugs, based on your previous comment - use channels 2 and 4 for ruddervators?

How would I get the spoilers to function using the proportional throttle stick for variable control of them? Is there a way to do this, or would they have to be on a knob like VR1, or switch?

Thanks again for your help!

Rob
Old May 19, 2009, 02:46 PM
MikeMayberry is online now
Find More Posts by MikeMayberry
Hitec/Multiplex USA
MikeMayberry's Avatar
It's best to call about programming as it's sometimes difficult to explain via the forums or e-mail.

(858) 748-6948

Mike.
Old May 23, 2009, 10:56 AM
robh is offline
Find More Posts by robh
Good, fast or cheap, pick two
robh's Avatar
Hi Mike,

PM sent...

Thanks,

Rob


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Setting up a motor glider with Eclipse 7 svenhaa Foamies (Kits) 2 Jul 07, 2008 03:50 PM
Whoops! converting slo-v to brushless need help setting up v-tail. eggic Electric Plane Talk 5 Mar 20, 2008 09:25 PM
Discussion Help setting up my new copterx with a 401 gyro. SteveCH Mini Helis 2 Dec 26, 2007 05:50 PM
Discussion help setting up trex tail bigjake Mini Helis 16 Feb 20, 2006 03:44 AM
Help setting up a Voyager E with a Schultz 45 pequeajim Electric Heli Talk 6 Oct 11, 2002 09:51 PM