GeorgeyT's blog - RC Groups
GeorgeyT's blog View Details
Posted by GeorgeyT | Oct 25, 2017 @ 10:37 AM | 1,147 Views
Does anyone accualy help on this rc groups I have asked about 4 times for help on 4 difforent subjects seems all people do is look At it and don't bother trying to help I'm only asking a simple question can someone answer me please
Posted by GeorgeyT | Oct 25, 2017 @ 05:59 AM | 1,248 Views
Hello community just a quick question about the chameleon frame on the specs it says maximum stack height 20mm I am in the process of ordering parts now for my build I was going to go with the matek pdb vtx combined with the matek stm32f405 FC but I would like the vtx and pdb to be seporate so I'm going to order the pdb without vtx and the flight controller but was going to get the matek tramp vtx stackable for the top of the stack does anyone know wether the stack will be to high for The frame or should it be ok ?
Posted by GeorgeyT | Oct 05, 2017 @ 08:15 AM | 1,313 Views
I cannot connect to BLHeli also when I am in cleanflight and go to calibrate my ESC's they just beep beep at full throttle and then when moved to lowest value there is another beep beep but no tune in between to say they have been calibrated can anyone give me a suggestion ?
Posted by GeorgeyT | Sep 11, 2017 @ 01:53 PM | 1,105 Views
Hi everyone just need abit of help with setting up airmode in cleanflight I have set my air mode to activate when Acro mode is on because I have a stock transmitter I don't have space on my switches to make air mode a switch , I also have motor stop disabled when I am in angle and or horizon mode the motors spin at min set throttle but wen I switch to Acro/airmode the motors start spinning at full value and I don't get any movement on the throttle any suggestions ? Would it be better if I used a switch for airmode instead of LED's as they are not really visible anyway and I fly mostly fpv ? Constructive criticism welcome as I am quite new to all this !