Jay 123's blog View Details
Posted by Jay 123 | Jun 20, 2018 @ 01:24 AM | 1,371 Views
Key features:

Support Pit Mode

25mW, 200mW, 400mW and 600mW power switchable

One button frequency and power setup

OSD configuration using Smart audio

7-24V input with 5V output

MMCX+UFL connector


Posted by Jay 123 | May 29, 2018 @ 06:51 AM | 1,420 Views

Posted by Jay 123 | Mar 10, 2018 @ 03:16 AM | 5,104 Views
2 long range vtx, X2-ultimate and FX2-ultimate, 25mW/200mW/600mW/1200mW power switchable

Posted by Jay 123 | Dec 14, 2017 @ 01:38 AM | 2,352 Views

Specification and Parameters:
Output power: 25mW
Input power: 3.25.5V
Current consumption: 640mA-330mA(25mW)
Camera resolution: 600TVL
Video system: NTSC
Field of view: 120 FOV
Sensor: 1/4" Color CMOS
Video Format: AVI
Recording Resolution: VGA @ 30fps
Micro TF Card: Max 32GB
Operating Temp: -10 ~ 60 degrees C
Frequency: 5.8GHz 6 bands 48 channels,
with Raceband: 5325-5945 MHZ
Size: 22*20mm(L*W)
Weight: 5.8g

Recording Function:
Install TF card first, max 32GB TF card supported.
Press button 1 start recording, R3 will keep flashing
while recording.
Press button 1 again to pause recording, recorded videos
will be saved to TF card automatically and R3 will stop flashing.

Notice: Each recorded video will be within 10 minutes.
After that, a new round of recording will be started automatically.

Posted by Jay 123 | Nov 18, 2017 @ 01:28 AM | 2,762 Views

Key features:
Support 0.01mW Parameter-adjusting Mode
25mW, 50mW, 100mW and 200mW power switchable
One button frequency and power setup
OSD configuration using FC Uart (F3/F4/F7 with OSD)
5V to camera @ under 300mA

Posted by Jay 123 | Oct 31, 2017 @ 03:27 AM | 2,488 Views
Posted by Jay 123 | Oct 18, 2017 @ 10:19 PM | 2,325 Views

Posted by Jay 123 | Oct 17, 2017 @ 09:52 PM | 2,110 Views

Posted by Jay 123 | Oct 15, 2017 @ 08:01 PM | 2,062 Views

The FPV video transmitter with the greatest range is the AKK X2 at 4000m or 2.5 miles , only $16.05 at official website:

Posted by Jay 123 | Oct 14, 2017 @ 03:32 AM | 3,379 Views

Posted by Jay 123 | Oct 10, 2017 @ 10:48 PM | 2,065 Views

Posted by Jay 123 | Oct 09, 2017 @ 01:39 AM | 2,181 Views

Posted by Jay 123 | Oct 07, 2017 @ 04:19 AM | 2,467 Views
There is an increasing need for vtx, and the requirements of FPV men is in flux. It has been for some time since AKK X2 was released out, since it looks same as X1, so here we can make a comparison between them.

Both units are in an identical size, weight limitations should be taken into consideration since it is being listed on the laws of different countries gradually and both modules operate with switchable CH, FR and power. But it's the upgraded functions of X2 that we will talk about especially.
First X2 has a lc filter, which can filter the power and make sure you get clean video. It support parameter adjust and work with Betaflight, and compatible with BF OSD FC. It is worth mentioning that a great part of people need mmcx connector, thus they make out this type of X2 soon after we got those feedbacks.
Here is an instruction:

AKK X2 Instruction (2 min 6 sec)

Posted by Jay 123 | Sep 29, 2017 @ 02:53 AM | 2,363 Views
Posted by Jay 123 | Sep 26, 2017 @ 10:03 PM | 3,131 Views
After the release of AKK X1/X1P now come the X2/X2P, which are even better. All of the inspiration of AKK product design comes from the feedbacks of online consumers-the most voracious and active groups. This is a society in flux, it is the same with customer preferences...Read More
Posted by Jay 123 | Sep 20, 2017 @ 08:51 PM | 3,015 Views
New arrival-AKK Flight Controller F4
In production now, will be in stock soon~
Weight: 7.5gram
Size: 36MM*36MM
PCB Thickness: 1.2MM
Processor: STM32F405RGT6
Transmitter: MPU6000 integrated accelerometer/gyroscope
Preset firmware version:3.1.7-OMNIBUSF4SD
Signal of receiver supported: PPM/SBUS
Barometer: BMP280
OSD: Flight Control Board IMU with Integrated OSD, support ground station Betaflight OSD parameter configuring; support tunning PID with OSD by using remote controller; Transmitter power, frequency band/CH can be tuned with OSD based on the Betaflight.(Support FPV transmitter like AKK X2/X2P)
Galvanometer: Integrated Gal, power current consumption real time monitoring available
Power supply: Built-in power module BEC
SD card slot: standard SD card slot

...Continue Reading