lassehellsten's blog - RC Groups
lassehellsten's blog View Details
Posted by lassehellsten | Dec 12, 2015 @ 03:21 AM | 3,211 Views
Usual MrRCSound planned. Will mount TT25s as last thing to get CG right

Cut out machine gun "plates", drilled out barrels, painted matt black inside barrels, soldered LEDs as shown.
Took out foam close to landing gear. Drilled holes with long drill wellded to a rod.
Airbrushed main gear wells. Marine aircrafts had same colors in gear wells as undeside of wings, not zink green.

Changed motor to 580Kv. Tailretract from Unique Models Corsair with HK 5g MG servo. Tailgear doors from FMS P51. Wires pulling down and torsion springs opening them.

Landinglights connected to NERSswitch from Hansen Hobbies.
Gears in action
USB programmable(adjustable) retract and door sequencer for RC (1 min 1 sec)

Planes in action
In and out if the hangar (5 min 2 sec)
...Continue Reading
Posted by lassehellsten | Nov 26, 2015 @ 06:22 AM | 3,950 Views
Some pics on mods to my Mossie.

MrRCSound V4.1 board on top of wing down under!

Nacell foam cut-outs to leave room for TT25 transducers
Thin foam over wire channel and TT25 on top of it, epoxied, under man gear
video shows final result after painting

LEDs from Freewing changed to brighter attached to MrRCSound board´s LEDoutputs.
Landing lights with current limiting resistors and NERS switch from

MrRCSound Freewing Mosquito (0 min 32 sec)

Freewing Mosquito MrRCSound (2 min 26 sec)
...Continue Reading