gathered. Tools at the ready. This is to become the harness.
- Soldering station and associated materials
- Wire strippers/clippes
- Heat shrink
- Butane torch
- 12" or so of Cat6 nework cable with RJ45 connector
- IRC vTX connectors - 2-Pin (+12V and Grnd) and 5-pin (Video, Grnd, Audio) molex
- Stereo wire loom
I've cut the Cat6 to length, and removed about 3/4" of the PVC sheath off the end to expose the wire grounding shield and individually shielded (aluminum) pairs.
For more info about Cat6 and why it rocks, look here:
http://fpvlab.com/forums/showthread....For-FPV-(CAT-6)
Foil pulled back to expose the 26AWG wire pairs.
...Continue Reading