Latest R/C Blog Entries
| Jun 21, 2015 @ 08:03 PM | 1,723 Views
Here is what i used to hold my ZMR-250
In the second picture you can see where i removed the insert from the lid.
This just pops out.
I used two layers of 2.25 inch Kaizen foam. I split a 2.25 in piece in half and used one half for the foam inserted into the case lid and the other half is the first layer in the bottom.
I used 3M-77 spray to glue the second layer of foam to the bottom layer.
I made a layout from dollar store foam board before I did any major cutting.
It holds my charger, Radio, ZMR-250, Goggles etc....
This thing is very stout with the goal of safely transporting on an airliner.
I have not cut into the top foam layer yet.
The batteries are held very nicely between the layers of foam.
Only road trips so far with this case.
View all Images in thread
All Thread Images
Homedepot ZMR-250 case
Case with lid insert removed
Batteries fit snugly between the bottom foam and top foam insert
Foam board template
Nase 32 OSD and Frsky Telemetry
| Dec 29, 2014 @ 05:31 PM | 2,674 Views
Most diagrams showing connection setup for and OSD with FRsky telemetry are incorrect.
if your OSD only updates when the Nase32 is not armed see below to correct the issue.
The Frsky receiver must be connected to RC input 6 with the following CLI commands.
USA, NJ, Burlington
Posts Per Day:
Most active forum:
Pusher Prop Jet Models
(16.36% of user's posts)
Most active topic:
Me-329 Build............ 1/8th scale
(10.00% of user's posts)
Find all posts by theborg
Find all threads started by theborg
Find all attachments by theborg
Mar 26, 2017
Sep 28, 2004
Find all articles by theborg
Search This Blog
Showing Friends 1 to 2 of 2
EB-66C Team Member
The last 10 visitor(s) to this page were:
This page has had
All RCGroups content copyright © 1996 - 2017 by RCGroups.com.
Terms of Service
Mark Forums Read
Back to Top