Comments (5)
Add Comment
-
Views: 148
Got a few pieces cut out. Ordered more Depron from Grayson. -
Views: 130
Found enough foam to cut these. -
Views: 157
Forward fuselage section. -
Views: 127
Not glued together yet. Just wanted to see how its going to look. -
Views: 136
This is not a very clear picture so I'll snap a better one tomorrow. Basically I'm building the canopy hollow to start with. Also I'm going to try and make a clear canopy using a 2 liter soda bottle. -
Views: 118
The control arm will go on the inside. Its just stuck on there temporary. -
Views: 137
I made the bushings by cutting a piece of a CF arrow shaft. Got the arrows at Walmart for $3.00 -
Views: 126
-
Views: 167
-
Views: 156
-
Views: 163
-
Views: 156
-
Views: 160
-
Views: 170
I also put 1/8" plywood under the arm ends for motor support. And hopefully to keep the motor mount screws from pulling through. -
Views: 166
Finally got some paint on it. -
Views: 134
1/8" plywood for the center sections. 3/8" pine for the arms. I had an old printed circuit board quad frame part to use as my power distribution board.
-
Views: 181
Solder the LED/versatile unit to the power leads. -
Views: 193
Here it is all plugged together. -
Views: 175
I used a small piece of aluminum angle to mount the LED on the back of the bottom plate. -
Views: 183
Heres the LED and the FC board set in place. They still need to be secured using two sided tape. -
Views: 177
Top view. -
Views: 202
Just a shot of the Naza Lite assistant. -
Views: 190
Mounted on some FPV gear. -
Views: 193
This photo shows the connections. I learned that I had to do away with the U lead. I later plugged it back in and now it is Attitude only. Because I am using all stock Aerosky H100 equipment. Tx and Rx.