lawrence4's blog View Details
Archive for September, 2020
Posted by lawrence4 | Sep 25, 2020 @ 01:23 AM | 6,574 Views
Catch PYTH700 at Maiden Flight (0 min 43 sec)


PYTH 700
Wing Material 3mm EPS
Elevon 3mm Balsa covered with clear packages tapes
C.G 138mm
Wingspan 707mm
Length 428mm
Height 120mm
Weight 244g
Motor EMAX 1804 2480kV
ESC HOBBYWING 10A 2~3S no BEC
BEC Matek micro 5V 1.5A
Receiver DSM2 6ch
Servo EMAX ES08AII 8.5g x 2
Propeller 5030
Battery dualsky 3S 550mAh

First flight elevon setup:
Elevon outside end tip from level up 10mm.
Elevon movement range up and down 10mm.

Plan Download from: http://jivaro-models.org/pyth700/page_pyth_700.html...Continue Reading
Posted by lawrence4 | Sep 15, 2020 @ 06:28 PM | 7,091 Views
Space Ship Maiden Flight Failure (Flyjng Bomb) (0 min 28 sec)


Build to Crash.
Just like a flying bomb.
Posted by lawrence4 | Sep 11, 2020 @ 07:10 AM | 5,662 Views
If you don't need/want to customize the multi module firmware then you can use pre-compiled binaries available here: https://github.com/pascallanger/DIY-...odule/releases

To just use the firmware file selector here: https://downloads.multi-module.org/ .

Flashing from the Transmitter
For radios running OpenTX, there is an option to flash a precompiled firmware file to the multiprotocol module:

OpenTX: using the SD card browser

What you need:

A precompiled multiprotocol firmware file (.hex for Atmega328p or .bin for STM32)
A Flash from TX bootloader installed on an Atmega328p or STM32 multiprotocol module
A means to get the firmware file onto the transmitter's SD card
OpenTX 2.3.3 or newer
Copy the firmware file to the radio's SD card - it doesn't matter where you put it
Switch the radio on normally and use the radio SYS menu to locate the file on the SD card
Highlight the file and press the ENTER button
Choose Flash internal module or Flash external module as appropriate