ChrisBowker's blog archive for April, 2012 - RC Groups
ChrisBowker's blog View Details
Archive for April, 2012
Posted by ChrisBowker | Apr 18, 2012 @ 09:53 AM | 10,565 Views
I'm happy to say that I have finally gotten my indoor carbon hardware kits to the point that I'm ready to start selling them. For now three kits and two motor mounts are available. These three kits are intended to be a "complete hardware" kit for a 3mm indoor foamie. They all consist of 1x Biased aileron horn(or diff horn for short) 2x aileron horns, and 2x tail horns(one short for the Elevator and one long for the Rudder. The AM kits also include 2x tail servo arms. All kits come as pictured in the photo's, pre-sanded and ready for use.

The biased aileron horn included in these kits have the "Z bend" connection points drilled on a radius to provide 4 different angles(11, 21, 31, 41) that your aileron pushrod can run at and still be at 90 digress to the center of the servo arm(doing this provides an even amount of up and down throw on your ailerons) I will up load detailed instructions on how to go about setting this up for those of you who do not know.

The first two kits(see photo's one and two) are intended for AM(freestyle) models with either push pull or pull pull control horns for the Rudder and Elevator. These are both seven piece kits. The holes in these for the "Z bends" are drilled to .023" making them perfect for .025 music wire. The Holes in the Pull pull horns are drilled to .032 and work well with most of the thinner pull pull string everyone is using now days. A complete set of the pull pull hardware with the generic...Continue Reading