shadowless's blog - RC Groups
shadowless's blog View Details
Posted by shadowless | Jul 03, 2012 @ 10:10 PM | 2,732 Views
CNC my gimbal recently.

My initial test was with cheap Hobbyking Corona 939mg digital servo and there was a lot of jerky motion. After I installed the Futaba S3156, it works much better. In the video the servos were powered by NAZA gimbal output so it was still a bit slow. Going to run them at 6v next round.

gimbal (1 min 42 sec)

Posted by shadowless | Jul 02, 2012 @ 09:40 PM | 2,536 Views
skyline (2 min 22 sec)