Gedexas's blog archive for November, 2011 - RC Groups
Gedexas's blog View Details
Archive for November, 2011
Posted by Gedexas | Nov 27, 2011 @ 04:55 PM | 5,669 Views
Both, the Belt CP v2 and the HBK4 have the exact same main rotor heads, so this will be short.

For this you will need two M5.5 sockets, a set of Allen drivers (1.5, 2.0, 2.5 & 3.0 mm). Some paper towels, spindle grease and a few other bits.

These are the offending dampers, I'll order harder ones next, but these should hold another 40 flights or so.

After removing blades, disconnect blade grip links, then unbolt and carefully remove the feathering shaft, don't spill the pieces all over the place. The parts in the picture below are placed in the order they are mounted. Before putting it all back, clean the old grease and slap on some new stuff. The inner thrust bearing halves fit less snugly on the feathering shaft, the bearing races go cupped side in.

...Continue Reading