The_Mongrel's blog archive for August, 2009 - RC Groups
Shop our Airplanes Products Drone Products Sales
The_Mongrel's blog View Details
Archive for August, 2009
Posted by The_Mongrel | Aug 27, 2009 @ 12:57 AM | 7,784 Views
Hello All,

Well I finally finished my wings for my Big Wing Easy Star and I am very happy with the result. The airbrush work is a little rough around the edges... but you get that when you are a hack!!

Anyways... I use Metallic Blue Profilm on the underside of the wings to give it a sleek look. I am going to weigh her again and if the increase is not too bad, I will do the tail also. I was really surprised at how covering on foam turned out.

Posted by The_Mongrel | Aug 12, 2009 @ 05:52 AM | 8,972 Views
Today I finished the build on my Easy Star, although I have not flown it in this configuration (still setting up) I am happy with the results.

I weighed it today for the first time and it came in at 1350g. Not too bad considering what is onboard.

Easy Glider Wings with Ailerons
EagleTree OSD Pro
Eagletree eLogger V3
Pan and Tilt
Enlarged Rear Stab with TX mounted.
Thomas LRS
3000mAh Main Lipo
500mAh Video Pack
Carbon Fibre in the tail for strength.
Main Rx in the Belly Hatch
3A/6A BEC (for safety)

Hopefully I will be able to send it up later in the week.

Posted by The_Mongrel | Aug 08, 2009 @ 03:44 AM | 7,894 Views
Today I sent my EZ Star up with the OSD on its maiden flight.

I am not sure if the GPS is still happening as it should - might need to look into this a little more. I have also now changed out the lens on the camera to a wider angle. Seems to give a brighter picture too.


OSD Test Flight (3 min 4 sec)

Posted by The_Mongrel | Aug 07, 2009 @ 09:32 AM | 8,008 Views
Well after some recent success with my Easy Star, I decided to go and see if I could setup my EGO Cessna for FPV. After some head scratching, I managed to get everything mounted, but it flew like a pig, so I decided (with some advice from a forum member) to drop the Video Battery and run everything off one Lipo. I also went back to the stock whip antenna on the TX.

The result was a much lighter airframe. I modified the battery box, and got ready for some fun.

The result is below. I will post some pics tomorrow of this bird, but what a hoot to fly. I have to be on my toes, because the ground rushes by a lot faster than with the Easy Star!!


FPV Cessna Maiden (3 min 55 sec)