jlorenco's blog archive for May, 2010 - RC Groups
jlorenco's blog View Details
Archive for May, 2010
Posted by jlorenco | May 10, 2010 @ 01:39 AM | 4,281 Views
This one quick 3D plane. You have to have quick thumbs to stay on top of this thing, but it can do amazing 3D stunts! Super slow harrier. I heard the nose was weak so I fabricated carbon fiber sides for it. I've lost control in low hover more than once with no damage.
Posted by jlorenco | May 10, 2010 @ 01:32 AM | 3,856 Views
What a super EPP plane! This little plane is really quick and agile and can fly super slow in harrier. I set it up with LEDs for night flight. What a blast flying it in the dark! It is easy to see and adds a whole new dimension to flying.
Posted by jlorenco | May 10, 2010 @ 01:23 AM | 4,379 Views
Yet another Pitts! This EPP plane is a great flyer and super durable. It isn't a 3D maniac, but does most of the 3D moves well. The control response is medium quickness, but very positive which makes it easy to fly down low with confidence. Great plane in the wind too. Since the fuse and wings are solid EPP, I tucked the Rx and wiring in the foam to clean it up a bit.
Posted by jlorenco | May 10, 2010 @ 01:11 AM | 4,324 Views
This was my first Depron scratch build, a Pitts Python. It came out lookng really nice, but unfortunately, I got carried way with the paint and trim and it got way too heavy. It still flew quite well even though it was about 13 oz. when it should have been about 7-9 oz. Had a lot of wing rock though, but very docile yet responsive. I plan to build another one - much lighter and use EPP.
Posted by jlorenco | May 10, 2010 @ 12:59 AM | 3,740 Views
My first introduction to 3D flying was with an e-foamies Revolution 3D. Great 3D trainer and very durable. I crashed this countless times practicing low level, close-in 3D and it just bounced off the ground, or needed minimal repairs. I passed it along to another pilot who is still flying it!