bongmaster's blog - RC Groups
bongmaster's blog View Details
Posted by bongmaster | Feb 21, 2010 @ 08:36 AM | 2,797 Views
as posted in another thread on the subject.

I have been thinking on the, lines and have blocked out a rough model for an EPP F-302

Materials: EPP and Carbon fibre rods.

tho this desigm would probably suit an indoor foamy.. it may work with a little more thought and actual measurements

...Continue Reading
Posted by bongmaster | Feb 19, 2010 @ 12:01 PM | 2,449 Views
Well i completed the build this morning when i fitted the electrics and set the cg

Tho it is balticly cold outside and the local clubs indoor flying meet isnt until the 27th, so i dont get to test fly it just yet

So i hope all is well XD
Posted by bongmaster | Feb 18, 2010 @ 03:37 PM | 2,956 Views
Ok so i got a little over excited and jumped into the build without documenting a single step :3

I am in the process of fitting the pushrods.. so far so good.. after that its the firewall and motor

So yea.. no pics or steps of the build XD.. all i can say is get more glue than u think u will need XD

and make sure u glue the controll horns on the right side of the rudder -_-

Pics later XD
Posted by bongmaster | Feb 17, 2010 @ 08:17 AM | 3,162 Views
So yea.. i kind of just noticed i have a Blog on here XD

I shall endevour to at least try and use it XD

Tho it is my birthday today so a good time to start as any XD


For my birthday my gf took me to the local RC hobby shop (hobby-24) and i got a new foamy :P

A Techone Piaget-epp and an Emax BL1812/11 motor for it :3

since its my 1st foamy i shall probably documant the build in hope than any other noobies who get the same plane or something similar can see how the build is for a 1st timer (in a foamy sense anyway)

watch this space :P