Comments (0)
Add Comment
-
Views: 271
Just opened the box. -
Views: 284
Landing gear and included hardware. -
Views: 277
Everything intact and well packaged. -
Views: 264
Aileron servos may be installed either outboard in the wing (2 servos) or a single servo in the wing center. Photo shows preinstalled string for pulling servo leads. -
Views: 263
Pushrod sleeves preinstalled. -
Views: 261
Hatch is held by magnets. Works great. Plenty of room for a 3.6 amp 3s battery.
Sticky:
Current
-
Views: 373
Pat's Custom Models - Grumman AgCat - under construction -
Views: 345
Pat's Custom Models - Grumman AgCat - under construction -
Views: 341
Pat's Custom Models - Grumman AgCat - under construction -
Views: 362
Pat's Custom Models - Stinson Reliant - 60" span - needs completion -
Views: 350
Pat's Custom Models - 60" span JN-4 Jenny - under contruction -
Views: 367
6mmFlyRC F4D SkyRay - needs repairs, crashed on maiden, destroyed front end. -
Views: 369
Pete Rake/Manzano Laser - Sperry Messenger - need to complete repair of crash damage. -
Views: 349
Pat's Custom Models - Fleet Bipe - need repair, flys very nicely
-
Views: 370
I have no idea who this might be or what he is flying. -
Views: 386
This was my Goldberg Falcon 56. Power was Enya .19, guidance by MRC (Futaba). Flew very well. -
Views: 370
Top Flite P-51B, covered by Monocote, guidance was EK Logitrol. Beautiful Aircraft--lost coming out of a split S (high speed stall and snap roll into the ground) -
Views: 379
Does anyone recognize any of these people? -
Views: 398
Same Question? -
Views: 404
Goldberg Senior Falcon- powered by a Wankel. -
Views: 398
-
Views: 406
I threw this in to see if anyone might be able to recognize the sky line. There is a drive-in theater in the distance. North of Cheyenne Ave and east of Tonapah Hwy (if memory serves-it was a long time ago).
-
Views: 442
This is one of the handiest tools on my bench. Balsa stripper by Master Airscrew. -
Views: 403
Strips cut for making rib blanks -
Views: 404
Sawing strips into blanks -
Views: 394
Blanks cut -
Views: 409
Making master ribs from 1/8 poplar ply -
Views: 412
Masters ready. -
Views: 386
Masters cut and sanded -
Views: 414
Rib stack ready for shaping
-
Views: 550
Wing before airfoil shaping -
Views: 515
Fake ribs, fabric and fabric filled with WBPU -
Views: 510
This wing bottom covered with .6 oz fiberglas. Not very satisfactory! -
Views: 485
Bottom of stab. Covered but not filled -
Views: 521
Illustration of fuse construction. Weight at this point with motor is 9.3 oz. -
Views: 490
Top of stab, covered but not filled -
Views: 512
-
Views: 481
Elevator cut out