Key features:

Support Pit Mode

25mW, 200mW, 400mW and 600mW power switchable

One button frequency and power setup

OSD configuration using Smart audio

7-24V input with 5V output

MMCX+UFL connector

MIC

https://www.akktek.com/akk-fx2-ultimate-mini.html

http://quadifyrc.weebly.com/reviews/...ng-term-review

https://www.akktek.com/products/vtx.html

2 long range vtx, X2-ultimate and FX2-ultimate, 25mW/200mW/600mW/1200mW power switchable
https://www.akktek.com/akk-x2-ultimate.html
https://www.akktek.com/products/vtx/...-ultimate.html

https://www.akktek.com/products/micr...s/akk-eio.html

Specification and Parameters:
Output power: 25mW
Input power: 3.2–5.5V
Current consumption: 640mA-330mA(25mW)
Camera resolution: 600TVL
Video system: NTSC
Field of view: 120° FOV
Sensor: 1/4" Color CMOS
Video Format: AVI
Recording Resolution: VGA @ 30fps
Micro TF Card: Max 32GB
Operating Temp: -10 ~ 60 degrees C
Frequency: 5.8GHz 6 bands 48 channels,
with Raceband: 5325-5945 MHZ
Size: 22*20mm(L*W)
Weight: 5.8g

Recording Function:
Install TF card first, max 32GB TF card supported.
Press button 1 start recording, R3 will keep flashing
while recording.
Press button 1 again to pause recording, recorded videos
will be saved to TF card automatically and R3 will stop flashing.

Notice: Each recorded video will be within 10 minutes.
After that, a new round of recording will be started automatically.

Key features:
Support 0.01mW Parameter-adjusting Mode
25mW, 50mW, 100mW and 200mW power switchable
One button frequency and power setup
OSD configuration using FC Uart (F3/F4/F7 with OSD)
5V to camera @ under 300mA

https://www.akktek.com/akk-nano2.html

...Continue Reading

ZD Racing "Thunder" 10421 - S 1:10 Off-road RC Buggy / AKKTEK A5 aio vtx (36 min 24 sec)

AKK BA2 FPV Transmitter Cmos Mini FPV Micro AIO Camera with Brass Dipole Antenna (16 min 26 sec)

...Continue Reading

The FPV video transmitter with the greatest range is the AKK X2 at 4000m or 2.5 miles , only $16.05 at official website:
https://www.akktek.com/akk-x2.html

There is an increasing need for vtx, and the requirements of FPV men is in flux. It has been for some time since AKK X2 was released out, since it looks same as X1, so here we can make a comparison between them.

Both units are in an identical size, weight limitations should be taken into consideration since it is being listed on the laws of different countries gradually and both modules operate with switchable CH, FR and power. But it's the upgraded functions of X2 that we will talk about especially.
First X2 has a lc filter, which can filter the power and make sure you get clean video. It support parameter adjust and work with Betaflight, and compatible with BF OSD FC. It is worth mentioning that a great part of people need mmcx connector, thus they make out this type of X2 soon after we got those feedbacks.
Here is an instruction:

AKK X2 Instruction (2 min 6 sec)

https://www.akktek.com/

After the release of AKK X1/X1P now come the X2/X2P, which are even better. All of the inspiration of AKK product design comes from the feedbacks of online consumers-the most voracious and active groups. This is a society in flux, it is the same with customer preferences...Read More

New arrival-AKK Flight Controller F4
In production now, will be in stock soon~
http://www.akktek.com/products/fligh...ollers/f4.html
Weight: 7.5gram
Size: 36MM*36MM
PCB Thickness: 1.2MM
Processor: STM32F405RGT6
Transmitter: MPU6000 integrated accelerometer/gyroscope
Preset firmware version:3.1.7-OMNIBUSF4SD
Signal of receiver supported: PPM/SBUS
Barometer: BMP280
OSD: Flight Control Board IMU with Integrated OSD, support ground station Betaflight OSD parameter configuring; support tunning PID with OSD by using remote controller; Transmitter power, frequency band/CH can be tuned with OSD based on the Betaflight.(Support FPV transmitter like AKK X2/X2P)
Galvanometer: Integrated Gal, power current consumption real time monitoring available
Power supply: Built-in power module BEC
SD card slot: standard SD card slot


...Continue Reading