Comments (0)
Add Comment
-
Views: 150
Perf board with adhesive-backed copper foil traces. -
Views: 159
Soldered up and potted in Epoxy. The copper traces were given a good tinning. -
Views: 171
-
Views: 163
-
Views: 154
-
Views: 162
Variant with wiring for a specific receiver. -
Views: 162
The other end. That's a custom header on the receiver, too. -
Views: 152
-
Views: 302
VFR for R9. -
Views: 297
Receiver link quality for Ghost. -
Views: 307
DIY crosshair type antenna as used on the Ghost module. -
Views: 310
Antennas set-up on the model. The antenna on the left was for R9. The Ghost Atto receiver with FrSky monopole is on the right. Each receiver used only one antenna.
-
Views: 342
The untrimmed nose. The cardboard cylinder is used to mark the cut line... -
Views: 341
...Like so. Simple and effective. A little down thrust added by eye. -
Views: 336
Judging from the oval section, I wonder if this might be the non-electric version of the fuselage. -
Views: 375
Will a round firewall fit into that oval? -
Views: 340
Yes, it will. That's the Vladimir's spinner that we're aiming to fit. -
Views: 339
The fuselage is cut at the right diameter, but the firewall is a little loose. Usually I turn my own firewall to fit the fuselage at hand. This firewall was a purchased unit left over from another project. -
Views: 348
Not to worry. A build-out with glass and epoxy will take up the extra space. And add a little more strength. -
Views: 340
A view of the firewall.
Sticky:
Art Hobby Sky-EC build pics
-
Views: 351
Machining an aluminum motor mount on the Taig. -
Views: 333
Homemade indexing fixture and extended length cross slide make this job possible. -
Views: 339
Rough cut. A few minutes with a Dremel and sanding drum will open it to final dimensions. -
Views: 343
The finished mount ready to be installed. Two layers of lightweight FG added to beef up the interior of the snout. The mount can accomodate a Reisenauer or small Maxon GB. -
Views: 338
Tray for the rudder and elevator servos, 2 of D47. -
Views: 341
Rails epoxied to fuse interior, 1/16th ply. -
Views: 342
Tray epoxied in place. -
Views: 323
JB-Weld used on mount.