Archive for December, 2013
-
Views: 189
Dagger at evergreen aviation -
Views: 179
quartering view -
Views: 206
left side -
Views: 211
Intake shot -
Views: 168
Tail shot -
Views: 163
Rear close up. -
Views: 189
Rear hump construction, l have a recessed portion inside to clear my rocket motor mount, not needed if you are just running electric. -
Views: 197
Wing and tail strakes
Comments (2)
Add Comment
-
Views: 195
Airframe pieces with carbon installed in the nose/wing. -
Views: 191
Fuse done and wing dry fit. -
Views: 200
markings on the wing completed and wing installed. -
Views: 212
Bott9m showing component placement. -
Views: 212
Ready for maiden! -
Views: 174
Dart at the Evergreen Aviation Museum -
Views: 154
Dart with me and my Dart after flying it at the RC field -
Views: 168
View of ducting from the rear
-
Views: 104
Completed Model -
Views: 122
Liftoff! -
Views: 124
Kit as it comes in the box. -
Views: 114
Parts unfolded and layed out. -
Views: 120
Apply CA+ to the wing at the tape joint. -
Views: 123
CA+ the wing spars, and set with accellerator, tape each spar the full span with blenderm tape. -
Views: 97
CA+ the fuselage top view at the tape joint. -
Views: 122
Lay the fuse to view with bottom facing up.
-
Views: 203
Tractor setup ready for maiden, what a dog! -
Views: 195
Full flying tail now without ailerons and rocket mount. -
Views: 200
Motor wires installed for pusher -
Views: 219
Removable motor pod with grayson microjet V-3 and apc 6x4 -
Views: 242
Pusher insalled, with trimmed rudder for prop clearance installed forward of original rudder LE. -
Views: 235
Ready for re-maiden, what a difference!