Archive for February, 2018
-
Views: 77
Position 0 and 1 are set to -100% for Self Level ON -
Views: 84
The Warnings page is used to select the Gear position 2 as ON. -
Views: 82
For further protection against accidentally turning Self Level Off use a small bungee and two pieces of fuel tubing. This spring loads the B switch to the 1 or 0 On postions. Put your finger under the band and lift it off the B switch if you prefer. -
Views: 72
Comments (0)
Add Comment
-
Views: 97
Pandora next to Sig 60” T Clips. -
Views: 99
Pandora top wing option. A battery hatch makes battery connections easier. -
Views: 106
The Tricycle main gear is bolted forward to make the taildragger option. The axles are further forward than normal and reduces tip over when operating on rough terrain. -
Views: 102
Wheel collars are used to limit left and right movement of of tailwheel and up movement of tiller music wire. A brass tube acts as a bushing that is CA’d to the foam. The stock plastic tailwheel support remains as a reminder of the problems it caused! -
Views: 122
After the axle is pushed thru the foam it is bent to the angle of the rudder. Wood on either side of the wire turns out the axle. The fiberglass cloth CA’d to the wood and rudder prevents the tailwheel from dropping down and hitting the elevator.