Comments (0)
Add Comment
-
Views: 50
Pushrod Support Made from Large R/C Hinge -
Views: 53
Battery Tray for Smaller Batteries -
Views: 60
Battery Tray Sketch -
Views: 55
Battery Tray with Smaller Battery Velcroed in Place Being Slid into Battery Compartment -
Views: 51
Receiver/ESC Wire Routing with XT30 Extension -
Views: 51
Red MonoKote Trim Patches on Top -
Views: 48
Black MonoKote Trim Patches on Bottom -
Views: 50
Nylon M3 12mm Standoff Glued into Fuselage Just Behind Inlet
-
Views: 52
Integrated mount for HDZero Camera, Transmitter, and Antenna mounted to Nano-Goblin canopy -
Views: 51
Nylon M3 standoff location on canopy -
Views: 49
Canopy reinforcements -
Views: 50
HDZero mount - top view -
Views: 52
HDZero mount - bottom and left side -
Views: 52
HDZero mount - bottom and right side -
Views: 53
Low Pass -
Views: 60
Following another flying wing
-
Views: 244
Figure 1 - Three-View Drawing of E-fficiency Electric Powered Glider -
Views: 220
Photo 1 - E-fficiency Electric Powered Glider on Snow -
Views: 219
Photo 2 - E-fficiency Electric Powered Glider in Flight -
Views: 257
Figure 2 - Aileron Effect of Inverted V-Tail that Increases Roll Rate -
Views: 249
Figure 3 - E-fficiency Disassembled -
Views: 219
Chart 1 - Glide Performance of E-fficiency Electric Powered Glider and Comparison with Easy Glider Electric
-
Views: 196
UMX Radiam on Floats -
Views: 333
Float Installation Showing Location of Center Float, Outrigger Float, Front and Rear Strut Mounts and Struts -
Views: 184
Front and Rear Strut Mounts Showing Struts, Red Teflon Pushrod Sheathing Tubes and Silicone Fuel Line Tubing -
Views: 173
Strut Mounts and Mounting Pads -
Views: 187
Outrigger Float Parts, and Partial Assembly -
Views: 257
Outrigger Float With 1mm Depron Top And Bottom Wrap Glued to the Bottom of the Outrigger Float, and Ready to be Wrapped and Glued to the Front and Top of the Float -
Views: 189
Horizontal Outrigger Float Struts Located in Slots in Top of the Center Float -
Views: 180
Horizontal Outrigger Float Struts and Float, Forward Strut and Center Float Mount Note Approximate 1/4-inch Clearance Between Prop and Float