Posted by blade strike |
Jul 31, 2016 @ 04:57 PM | 45,342 Views
Since there has been some issue with some users slave transmitters being reset I decided to try to replicate it. I think I found what is going on. Please try the following and see if it helps.
Set the slave as master, go to RC configuration and then set to an opposite mode. So if it's set to mode 2 set it to mode 1, hit apply. Then go back and reset it back to mode 2 or whatever mode you fly. Once that is done go ahead and put it back into slave mode.
Make sure on the MASTER coach mode is set to OFF, I have seen on some controllers this defaulting to ON. Now on the slave search for master, select it and enter password for the master. Once linked please request control or access on the SLAVE and agree to it on the MASTER. Now you should have all normal slave control. More than likely you will need to reconfigure your stick inputs to desired functions if a custom mapping was used.
Posted by blade strike |
Jul 30, 2016 @ 10:28 AM | 46,254 Views
RC Combinations:
Try to reset the remote controller.
* Turn on the controller, and make sure the aircraft is off.
* Press C1, C2, and shutter on the controller and then turn the controller off.
* Turn on both the aircraft and the controller and link the remote.
How to force the controller to update:
* Turn on the controller, and make the aircraft is off.
* Press C1, C2, record and the wheel on the right side of the controller and then turn off the controller.
* Don’t let go of any of the buttons, turn on the controller. Then the controller will be able to update again.
How to link the remote via the combination buttons on the controller:
* Turn on both the aircraft and the controller.
* Press C1, C2, and the record button on the controller, then the controller will beep like D-DD.
*Let go of the buttons, the press the wheel on the right side of the controller. The first light of the controller will become blue and it will constantly beep DDDD.
* Use a small tool to press the linking button on the aircraft and hold for 3-5 seconds, release the linking button and wait, it will link in a few secnds.
How to link the remote on P3S:
Turn on RC, move the wheel to the very left and flip the S2 up and down three times and press the link button on the aircraft for 3-5 seconds.
How to reset WIFI on P3S?
Turn on the RC and move the wheel to the very right, switch S2 up and down for three times very quickly and turn off RC, and then turn RC back on again. The WIFI is then reset.
About blade strike
