Archive for August, 2012
-
Views: 196
Here is the final weight on the fling. This is with everything in it, prop and all. Not horrible. -
Views: 199
I have seen guys use super tiny servos in the fling fuse set side by side on the diagonal. I just have a ton of those 2.50 servos from China and whatever hand me downs I get. So I cut into that beautifully smooth fiberglass and put in my servos externally -
Views: 197
Here is the cheap of the cheap. I got these off Hobby King years ago. I bought like 10 of them. Down to my final 4. They do burn out, and what a show they put on whilst in the air. The screeching electronic death sound, followed by copious amounts of smok -
Views: 192
View #2 -
Views: 188
The carbon fiber rod one side and a piano wire rod on the other. Nothing is good for this pig. Of course they bowed on the push from the servo... so what do I have around here that's small enough.... er.... AH! The end of a zip tie! With the middle thingy -
Views: 205
The innards revealed! With the servos outside, I have all this room inside. At least this is where the servo board USED to be. Now it has the 15amp speed controller and the 500mh lipo battery. I also cut into that seamless body again to put the wires in f -
Views: 194
What you CAN'T see and what is most important. Where is the receiver? I use the best of the best *snicker*. I have the 6 channel Hobby King 2.5ghz $26.99 Tx special. With those HUGE clunky $7.00 receivers. They are actually nice and tiny when you remove t
Comments (2)
Add Comment