Posted by Knoll53 |
Jun 10, 2010 @ 10:20 AM | 10,036 Views
This project is a semi-scale slope glider. The wing will be vacuum bagged foam and the fuse will be a laser cut framework with fiberglass and lots of auto body filler.
Currently I am considering MH60 at the root and SD8020 at the tip with 6 degrees of linear twist. I would use 2 panels per side with a wing twist distribution that more resembles a bell shaped lift distribution if I had more knowledge of the subject. Does anyone have a suggestion before I fire up the hot wire?
Kent