Bugbitten's blog View Details
Posted by Bugbitten | Jul 18, 2013 @ 09:33 PM | 4,790 Views
On my DX8 I had set up a slight up elevator on a switch. Hand launch and flick the switch for flight trim. I am clueless on how to do this on my 18. Don't remember what I did on the 8.

I use the flaps menu for that. Just assign the desired elevator deflection to the launch switch position, leaving the flaps at 0. You can also program the speed of the change. If you have no flaps, never mind. Just pretend you have them and assign them to an unused channel. I find this the most natural and elegant way.
Posted by Bugbitten | Jul 18, 2013 @ 09:27 PM | 5,281 Views
The TM1000 and TM1100 are designed to work with Data ready receivers in order to fully use telemetry including Flight Log.

When using it with any other receiver, you should remove the signal wire from the Data cable you connect the TM unit to the receiver.

In some cases the signal wire connected to a NON Data ready receiver will cause the unit to go into BIND.