Comments (0)
Add Comment
-
Views: 316
Tools that you may already have. -
Views: 241
After joining the rotors with balancer, hold against a striaght edge. Insure that the distance is the same here... -
Views: 240
...and here. -
Views: 238
Your balancer supports need to be the same height. -
Views: 234
Sanding blocks and balsa blocks. Note that the lower balsa bolck needs to be put paralell with lower sanding block. -
Views: 230
Add small strips of Scotch tape to high blade. Insure that the strips wrap around the leading edge of the blade. After getting them to balance, re-check the straight edge distances and balance again. Repeat as necessary. -
Views: 239
-
Views: 234
Note that all 3 holes are paralell.
Sticky: