TheMadCADer's blog View Details
Posted by TheMadCADer | Apr 20, 2019 @ 12:45 PM | 5,641 Views
After almost exclusively flying 5in and 6in quads for the past few years and being disappointed by the power of early brushed whoops, I was finally convinced to try out a brushless whoop that I have been hearing a lot of good things about, the Happymodel Mobula 7. I’m not a fan of large walls of text, so I’m going to try to keep this concise. I’ll talk a bit about my thoughts and observations after 20 flights, then setup and modifications.

Initial Thoughts:



The box has a sticker on it that says Jan 23rd, 2019, which I assume is the production date.
My unit came with an F3 flight controller (stm32f303), though there are others who claimed that theirs came with an F4 flight controller, so you may be luckier than me


...Continue Reading
Posted by TheMadCADer | Jul 26, 2016 @ 10:02 PM | 16,273 Views
Product Link: http://bit.lc/4zUt
Manual Link: http://img.banggood.com/file/product...r%20Manual.pdf
Firmware Update Instructions:
Version Updating:
flysky i6s 1.10 22-Mar-2016 to flysky i6s 1.11 30-Jun
Need to bind with receiver again, 2. The menu set contents will be reset, please reset your transmitter.
flysky i6s 1.11 07-Jun-2016 to flysky i6s 1.11 30-Jun
Need to reset and calibrate the stick date. Please follow the calibration process to calibrate your transmitter.

Upgrade Process:
1. Connected the transmitter to the computer via USB cable.
2. Enter the Setup menu in the transmitter and navigate the Firmware Update section.
3. Open the firmware upgrade tool in your PC.
4. In the Firmware Update Section of the transmitter press Continue and the transmitter will enter the update mode.
5. Once the transmitter enters the update mode, you will see it listed in the software. Press Update in the software and the update process will begin. It should take a few seconds for the update to take place and then the transmitter will reboot.
6. Close the software and unplug the transmitter.
7. In the Setup section of the transmitter navigate to the About FS-i6S section to confirm the correct firmware.

Once the transmitter’s software has been successfully updated, it must be calibrated. Follow the following steps to calibrate your transmitter:
1- Enter the Setup menu and navigate to the Stick Adjust section to initiate the calibration process.
2-...Continue Reading