Comments (0)
Add Comment
-
Views: 166
Side pieces cut out... -
Views: 173
Better view of side pieces cut out. -
Views: 167
CNC Router drilling all the holes.....hundreds of them!!!! -
Views: 180
Still drilling... -
Views: 157
Weights added on top to weigh it down whilst the glue (no nails...well Screwfix "Sticks like Shit" brand actually which is just as good....) -
Views: 172
-
Views: 166
MK1 fro the top -
Views: 169
MK1 from the side -
Views: 188
MK1 separated -
Views: 169
MK1 separated again -
Views: 178
Trial run bending a welding rod..... -
Views: 189
MK2 wire bender -
Views: 185
MK2 wire bender. Welding rod clamped in as a trial -
Views: 314
MK2 wire bender showing the angle through the two dowels, the M8 clamp moves to allow different width wires to be tight between the two dowels.
-
Views: 1209
Quick Sketchup mock up of the cutter to get it in my head that it would work. -
Views: 285
First itteration of the bow on top of the Vacuum forming box I'm making. -
Views: 256
PSU with 12V switched mode PSU in it, snazzy illuminated computer fan and a voltmeter and ammeter to see what power the bow draws. -
Views: 278
Lots of M8 tapped holes on top of the 40mm x 25mm RSA. also see the sliding pulley used to set the % for cutting tapered wings. -
Views: 246
Another view of the M8 tapped holes. -
Views: 259
Swinging arm attached... -
Views: 456
-
Views: 257
Better view of the adjustable pulley holder. I cut too much of the back away so I'll re-make them with more support at the back for clamping. It works ok at the moment so will leave it until I have a problem.