Pierre_de’ Loop's blog View Details
Archive for April, 2016
Posted by Pierre_de’ Loop | Apr 11, 2016 @ 08:35 AM | 8,205 Views
The Kadet's wing panel fills my 36" building board. I pinned down the lower spars and too quickly test fit the ribs and trailing edge. But when I began gluing in the ribs, I found that my building board has multiple warps in it and the surface I was building on is progressivity concave. As a result, the front and back of the ribs sit on the board, but about halfway down the board the spars pined to it begin to move away from the notch in the ribs. Fortunately, I'm building with Titebond glue, so I had enough time to unpin the spars and pin them to the ribs, rather than the board. I stopped building there.

Later, I placed the wing on the flat surface of our kitchen island and felt relieved to find it is fairly straight. My chief concern was that the trailing edge would have a slight upward tilt, but this doesn't appear to be the case.

The obvious next step is order a nice new 48" building board, but Tower and Guillows appear to have stopped selling them.